Why can’t I join lines in AutoCAD?

Why wont my lines join in Autocad?

Causes: Objects have gaps or do not have connecting points because of different elevations. Use the UNITS command and increase the precision to maximum. Examining the lines, the Properties palette will show Start Z / End Z or Elevation values, potentially of a minute amount.

How do you join two lines in Autocad?

Just use the “Join” command.

1. Type “ Join” in command section.
2. Select the lines to be joined and press enter. That’s it.

What’s the opposite of explode in AutoCAD?

There is no “unexplode”: you can use BLOCK command or BEDIT command to make a new block. Hi, the command you are looking for is “join”, it will connect all the lines you select. To execute this command you need to turn all the lines you want to join into polylines if they aren’t already.

What does Ltscale do in AutoCAD?

Linetype scale (LTSCALE) determines the scale and appearance of dashed lines as they appear in your drawing. This setting becomes especially important when you go to plot, since lines that appear dashed in Model Space may appear solid in Paper Space if their LTSCALE isn’t exactly correct.

What is Pedit in AutoCAD?

Edits polylines, objects to be joined to polylines, and related objects. Find. Common uses for PEDIT include joining 2D polylines, converting lines and arcs into 2D polylines, and converting polylines into curves that approximate B-splines (spline-fit polylines).

How do you join two lines?

It’s possible to use two phone lines without using a two line phone, but you have to either rewire your wall jacks or purchase a two-line splitter. These devices plug into a standard two-line jack and split the line, directing the first line to one jack and the second line to the other jack.

How do I fix a broken line in Autocad?

Solution:

1. Unlock, thaw, and turn on all layers.
2. Choose a point close to the objects and note down its coordinates.
3. Type MOVE and press Enter.
4. Type ALL and press Enter.
5. Choose the previously determined point as a base point and 0,0 as an end point. …
6. Save and close the drawing.