You asked: What is a aligned section view in Solidworks?

What is an aligned section view?

An aligned section view is drawn as if the cutting plane line ran straight across the object. The cutting plane line is rotated into a straight position, and the section view is projected.

What are the 7 types of section views?

There are a number of different types of sectional views that can be drawn. A few of the more common ones are: full sections, half sections, broken sections, rotated or revolved sections, removed sections, offset sections, and assembly sections.

What are the different views in Solidworks?

You can generate drawings of a part or assembly in a variety of view types: Standard 3 View, Model, and Relative views. The part or assembly document must be saved before you can create drawing views of it.

What is an auxiliary view in Solidworks?

An Auxiliary View is similar to a Projected View, but it is unfolded normal to a reference edge in an existing view. You can create an auxiliary view of an exploded assembly view. You can use sketched lines for folding.

How do you draw an aligned section?

To Create an Aligned Section View

1. Click Layout tab Create View panel Section drop-down Aligned.
2. Click the view you want to use as the parent view. …
3. Click in the drawing area to indicate the start point of the section line. …
4. Click in the drawing area to indicate end point of the first segment of the section line.

What is sectional front view?

The view obtained after removing the front half portion of an object is called a Full Sectional Views or Front Sectional Views or Simply Sectional Elevation. When the cutting plane cuts the object lengthwise, full sectional front view is obtained. It is also called longitudinal section.

What are the two important features of sectional view?

Rule 1: A section lined area is always completely bounded by a visible outline. Rule 2: The section lines in all areas should be parallel. Section lines shown in opposite directions indicate a different part. Rule 3: All the visible edges behind the cutting plane should be shown.

What does Section AA mean?

Removed Sections



A section removed from its normal projected position in the standard arrangement of views is called a “removed” section. Such sections are labeled SECTION A-A, SECTION B-B, etc., corresponding to the letter designation at the ends of the cutting plane line.

What is projected view in Solidworks?

Projected views are created by folding off an existing view in one of eight possible projections. The resulting view orientation is affected by the setting of First angle or Third angle projection as defined in the drawing sheet properties.

How do you create a section view in Solidworks drawing?

To create a section view manually:

1. Click Section View. (Drawing toolbar), or Insert > Drawing View > Section. …
2. To create a section view manually, click Edit sketch to display the Insert Line PropertyManager.
3. Sketch a section line. …
4. Click to place the view.

How do you get Trimetric view in Solidworks?

Click Tools > Customize and select or clear Use Large Tooltips to enable or disable the view previews. flyout button in the Orientation dialog box to select axonometric (isometric, dimetric, or trimetric) views and to set which type of axonometric view is displayed when you select a View Selector corner.

What is the difference between projected view and auxiliary view?

An Auxiliary View is similar to a Projected View, but it is unfolded normal to a reference edge in an existing view.

What surface that needs an auxiliary view?

When an object has a slanted or inclined surface, it usually is not possible to show the inclined surface in an orthographic drawing without distortion. To present a more accurate description of any inclined surface, an additional view, known as an auxiliary view, is usually required.

How do I create a detail view in Solidworks?

To create a detail view:

1. Click Detail View. (Drawing toolbar), or click Insert > Drawing View > Detail.
2. The Detail View PropertyManager appears and the Circle tool. is active.
3. Sketch a circle. …
4. When the view is where you want it to be, click to place the view.