Where is the split tool in Revit?

How do you split a model in Revit?

The sequence of this process is:

1. Open the model to split. If it’s a central model, detach and save it.
2. Open all worksets and reload all links.
3. Create a 3D Control View per phase, and set their Discipline to “Coordination”.
4. In each 3D Control View:

How do you split a wall in Revit?

Split Walls Horizontally

1. Click Modify tab Modify panel (Split Element).
2. Place the cursor on the wall or line at the point you wish to split. Note: A stacked wall can only be split vertically. …
3. Click to place the split. A permanent horizontal line displays on the wall indicating the split.

How do you split a viewport in Revit?

Divide a View Across Multiple Sheets

1. In a project, create and prepare the view that you want to divide into parts. …
2. Create dependent views. …
3. Create the sheets on which to place the dependent views.
4. Add the dependent views to their respective sheets.
5. (Optional) Add view references to the primary view.

When using the split with Gap tool where is the gap width assigned?

Click Modify tab Modify panel (Split with Gap). On the Options Bar, specify the Joint Gap dimension. Note: Joint Gap is limited to values between 1/16” and 1′ (Imperial).

What are Worksets used for in Revit?

In short, Worksets is a collaborative tool in Revit that provides an element of control to what people are working on. This feature is only available within a central model for collaborative working.

How do you split a wall with two colors?

To divide a wall with two paint colors vertically, choose a point on the wall where you want the two colors to meet, apply the first color which goes past that point, mark a vertical dividing line with a pencil or chalk, apply masking tape following that line, apply the second color on the remaining part of the wall …

How do you paint a half wall in Revit?

Click to select the wall face to split. Then, from the draw panel, select a tool to sketch the area to split. Like other sketch based elements in Revit, the sketch for the split face must form a closed loop. Click Finish to complete the split face area.

How do you rejoin a split wall in Revit?

You can remove a split in the wall by going to a top view and dragging the wall at the split away from the other, then dragging it back. Now it’s one wall again.

How do you split a slab in Revit?

Split a Roof or Structural Floor

1. Select the floor to modify.
2. Click Modify | Floors tab Shape Editing panel Add Split Line.
3. Select a vertex, edge, face or point anywhere on the structural floor to start the split line. …
4. Select another vertex, edge, face or point anywhere on the floor to end the split line.

How do you edit parts in Revit?

Edit a Part Division

1. Select one of the parts that resulted from dividing a larger part.
2. Click Modify | Parts tab Part panel (Edit Division). The original part displays in light blue and the division lines in green.
3. In this edit mode, you can do the following: …
4. Click (Finish) to exit the edit mode.

How do you split elevation in Revit?

To do this, select the elevation line, in the Ribbon select the Split Segments tool and pick the elevation line where you would like to split the line, then move the split segment to the desired location.

How do you do Matchlines in Revit?

Add a Matchline

1. Open the primary view from which your dependent views were created.
2. If crop regions are not visible, click (Show Crop Region) on the View Control Bar. …
3. Click View tab Sheet Composition panel (Matchline).
4. Sketch the matchline.
5. When finished, click Finish Matchline.