What is the difference between cut thread and extrude thread solidworks?

How do you cut a thread Extrude in SolidWorks?

Creating a Cut Thread

1. Open a model with a cylindrical part and click Insert > Features > Thread .
2. In the graphics area, select a circular edge.
3. In the PropertyManager, under Specification, set values for the following: …
4. For Thread method, click Cut thread. …
5. Set the starting position of the Thread Location:

How do you cut a thread in SolidWorks?

Creating a Cut Thread

1. Open a part file. The diameter of the cylinder is 6mm. …
2. Click Insert > Features > Thread .
3. In the graphics area, select the top edge of the cylinder.
4. In the PropertyManager, under Specification: …
5. Under Thread Location: …
6. Under End Condition, click Maintain Thread Length. …
7. Click .

Where is extrude thread in SolidWorks?

Using the Thread Tool



The Thread Tool can then be found underneath the Hole Wizard Tool on the Features tab of the Command Manager, or in Insert>Features>Thread.

What is a thread in SolidWorks?

The threading feature in SolidWorks offers you a much easier way to create threaded feature geometry on your parts. Previously you would need to sketch out the profile of your thread and the pitch with a helix. Now adding threads is as simple as a few clicks.

What is an internal thread?

Internal Thread: An internal thread is a thread on the inside of a member. Major Diameter: The largest diameter of the thread of the screw or nut. The term “major diameter” replaces the term “outside diameter” as applied to the thread of a screw and also the term “full diameter” as applied to the thread of a nut.

What are square threads called?

The square thread form is a common screw thread form, used in high load applications such as leadscrews and jackscrews. It gets its name from the square cross-section of the thread. It is the lowest friction and most efficient thread form, but it is difficult to fabricate.

What is screw thread size?

Diameter is also known as screw size. For those with a diameter smaller than 1/4″, screw size is indicated by a number (e.g., #10 or No. 10). For example, a 10-24 screw has 0.190″ thread diameter and has 23 threads per inch.

How do you extrude threads on cylindrical surface solidworks?

Start by creating a cylindrical extrusion or cylindrical hole, much like the initial steps to of making a cosmetic thread. The feature size should be the same as the nominal thread diameter. From there, select the starting edge. Then, click “Insert” then “Feature” and “Thread.” This will automatically create a thread.

How do you read thread size?

Thread sizes are given in nominal sizes, not in the actual measurement. The exact measurement is slightly below the named or nominal size. For example, a 6mm bolt may measure 5.8mm or 5.9mm, but it is called 6mm bolt. It is also common to use “M” before the bolt size, such as M6 for a 6mm bolt.

Why are rolled threads superior to cut threads?

For the same reason, rolled threads are often much smoother, and damage resistant during handling than cut threads. Thread rolling changes the mechanical properties of the material by work hardening it, resulting in increased wear and fatigue resistance, as well as enhanced shear, tensile, and yield strength.

What are standard thread sizes?

Standard Thread Pitch Chart

How do you show threads in Solidworks drawing?

To insert cosmetic threads from assembly documents into drawings, click Insert > Model Items and click Cosmetic thread . In drawings, Insert Callout appears in the shortcut menu.