What is an interference in SolidWorks?

What Does interference mean in SolidWorks?

If your assembly has a door or a sliding component, Interference Detection can determine whether that component has the correct range of motion, or if the component will be stopped short of the desired range. The Interference Detection tool can be found in the Evaluate tab, as shown below in Figure 1.

What is interference in an assembly?

Interference occurs when components of two independent parts attempt to occupy the same space. When working with multiple parts or the components of an assembly, you should frequently check for interference among them.

How do you add interference in SolidWorks?

You can select components to check and set options for types of interferences to find, and then calculate results. To open this PropertyManager: Click Interference Detection (Assembly toolbar) or Tools > Evaluate > Interference Detection.

How does solidworks measure volume interference?

To check for interferences in an assembly:

1. Click Interference Detection (Assembly toolbar) or Tools > Evaluate > Interference Detection .
2. In the PropertyManager: Make selections and set options. Under Selected Components, click Calculate. The detected interferences are listed under Results.

How do I clearance verify in Solidworks?

To check clearance: Click Clearance Verification (Assembly toolbar) or Tools > Evaluate > Clearance Verification. To display a clearance failure in the graphics area: Select it in Results in the PropertyManager.

How do you ignore interference in Solidworks simulation?

To ignore interferences less than a selected value:

1. In an assembly document, click Tools > Evaluate > Interference Detection.
2. In the PropertyManager, in Selected Components, click Calculate. …
3. Optionally, in the Results list, right-click a value and click Sort Largest to Smallest or Sort Smallest to Largest.

How do I run a Solidworks simulation with interference?

SOLIDWORKS Simulation has a built-in tool to detect where in an assembly the volumetric interferences are occurring. To access this tool please perform the following. Click Tools > Evaluate > Interference Detection > Calculate.

How does Onshape detect interference?

To get started with Interference detection, simply click on “Camera and render options” under the view cube menu in your Part Studio or assembly. Then click “Interference detection.” This will bring up the Interference detection dialog.

How do you change the clearance in SolidWorks?

Dynamic Clearance

1. Click Move Component or Rotate Component on the Assembly toolbar.
2. In the PropertyManager, select Dynamic Clearance.
3. Click in Components for Collision Check. …
4. Click Stop at Specified Clearance and enter a value in the box to prevent the selected components from moving within the specified distance.

Where is collision detection in SolidWorks?

Click Move Component or Rotate Component (Assembly toolbar). In the PropertyManager, under Options, select Collision Detection. If the component you are moving touches any other component in the assembly, the collision is detected.

How do you stop parts from moving through each other in SolidWorks?

Select Stop at collision to stop the motion of the component when it touches any other entity. The faces that touch the component you are moving are highlighted. The computer beeps when a collision is detected.

How can you create relationships between parts within an assembly?

To create a part within an assembly:

1. Click New Part (Assembly toolbar) or Insert > Component > New Part.
2. For externally saved parts, type a name for the new part in the Save As dialog box and click Save.
3. Select a plane or planar face (while the pointer is ).

What type of face can’t be selected when creating a concentric mate?

A coincident mate forces two planar faces to become coplanar. The faces can move along one another, but cannot be pulled apart. A concentric mate forces two cylindrical faces to become concentric. The faces can move along the common axis, but cannot be moved away from this axis.