How do you create an arc in Solidworks?
Menu. Clicking Tools, Sketch Entities to select arc tools. Arc PropertyManager.
…
To sketch 3 point arcs:
- Click 3 Point Arc. .
- Click to set a start point.
- Drag the pointer , then click to set an end point.
- Drag to set the radius.
- Click to set the arc.
- Click OK .
How do you construct an arc tangent to two lines?
equal to AB, tangent to CD and EF. Draw GH parallel to CD and at a distance from CD equal to the given radius of the arc. Draw IJ parallel to EF and also at a distance equal to the given radius of the arc.
What is a tangent arc in Solidworks?
Moving the pointer in a tangent direction creates a tangent arc. Moving the pointer in a normal direction creates a normal arc. You can toggle between tangent and normal arcs by returning to the end point and moving away in a new direction. Video: Sketching Tangent Arcs. Click .
How do you draw a 3 point arc in Solidworks?
To sketch 3 point arcs:
- Click 3 Point Arc .
- Click to set a start point.
- Drag the pointer. , then click to set an end point.
- Drag to set the radius.
- Click to set the arc.
- Click . Video: Sketching a 3 Point Arc.
How do you draw a circle in Solidworks?
Circles
- Sketch tab. Click the Sketch CommandManager to select circle tools from the Circle. flyout tool.
- Menu. Click Tools > Sketch Entities to select circle tools.
- Circle PropertyManager. Change to different circle tools from the Circle PropertyManager.
How do you draw a curved line in Solidworks?
on the Curves toolbar, or Insert > Curve > Projected. Use this selection to project a sketched curve onto a model face. , select the curve in the graphics area or from the flyout FeatureManager design tree. , select the cylindrical face on the model where you want to project the sketch.
How do you do a hole callout in Solidworks?
To add a hole callout:
- Click Hole Callout (Annotation toolbar), or click Insert > Annotations > Hole Callout. …
- Click the edge of a hole, then click in the graphics area to place the hole callout. …
- Edit the callout in the Dimension PropertyManager. …
- Repeat steps 2 through 4 to insert additional hole callouts, then click .