Question: How do you add a cog in Solidworks?

How do you add a gear in SOLIDWORKS?

From the Windows Start menu, click All Programs > SOLIDWORKS version > SOLIDWORKS Tools > Toolbox Settings. From the Configure Hardware page, click GB, Power Transmission, and then click Gears.

How do I make a SOLIDWORKS toolbox?

Welcome to Toolbox Setup

1. In SOLIDWORKS, click Tools > Options > Hole Wizard/Toolbox > Configure .
2. From Windows, click Start > All Programs > SOLIDWORKS version > SOLIDWORKS Tools > Toolbox Settings .
3. When Toolbox is loaded and a document is open in SOLIDWORKS, click Toolbox > Configure.

What is Toolbox in SOLIDWORKS?

The Toolbox is a collection of several powerful tools built into SolidWorks; it can increase productivity and decrease the time required to complete a design. The Toolbox contains a vast library of standard hardware components that can easily be dropped into a design at any point.

How do you model a spur gear?

Best Modeling of Spur Gear

1. Step 1: start with Sketch.
2. Step 2: use offset command.
3. Step 3: create tooth line and give dimension.
4. Step 4: Apply fillet like this.
5. Step 5: use circular pattern.
6. Step 6: use trim (power)
7. Step 7: Extrude.
8. Step 8: sketch on left face and use cut extrude.

How do you edit gear in SOLIDWORKS?

To edit Toolbox components from the Configure Component PropertyManager:

1. In the FeatureManager design tree, Shift + select the configurations to modify.
2. Right-click and click Edit Toolbox component. …
3. Modify component properties. …
4. Click .

How do you make a helical gear in SolidWorks?

Tutorial – Creating Helical Gear in SolidWorks?

1. Change the extrusion height and make it thicker.
2. Insert>>Feature>>Flex.
3. Choose flex type – Twisting and select the gear body as flex input.
4. Enter the triad angle for x axis as 90degree.
5. Enter flex angle(Helix angle) as 20degree. Click OK.
6. We have the Helical gear created.

How do you create an involute gear profile?

Draw a radial line from base circle on the right hand side to the pitch circle and another from the pitch circle to the new circle (the outside). Make these two lines equal length, so the outside circle is the same radial length larger than the pitch circle as the base circle is smaller.