How does solidworks calculate deflection?

How does solidworks measure deflection?

You can perform deflection and stress calculations on structural steel cross sections. Click Beam Calculator (Toolbox toolbar) or Toolbox > Beam Calculator . In the Beam Calculator dialog box, select a Load Type. Under Type of Calculation, select Deflection or Stress.

How is deflection calculated?

Generally, deflection can be calculated by taking the double integral of the Bending Moment Equation, M(x) divided by EI (Young’s Modulus x Moment of Inertia).

Can solidworks do stress analysis?

With SOLIDWORKS Simulation added in, you can perform stress, factor of safety, or deformation analysis of components without setting up loads and boundary conditions. The required loads are obtained automatically from a calculated Motion Analysis study.

How do I read SOLIDWORKS Simulation results?

Displaying SOLIDWORKS Simulation Results in the Graphics Area

1. Open an assembly that has a simulation study saved with it.
2. Click the Static 1 tab.
3. In the Simulation Study tree, right click Static 1 and click Run.
4. Click the Model tab.
5. Click Simulation Display (View toolbar) or View > Display > Simulation Display .

How is deflection limit calculated?

Typically, the maximum deflection is limited to the beam’s span length divided by 250. Hence, a 5m span beam can deflect as much as 20mm without adverse effect.

How do you calculate maximum deflection?

To calculate for the maximum deflection of a beam with a combination of loads, we can use the method of superposition. The method of superposition states that we can approximate the total deflection of a beam by adding together all the deflections brought about by each load configuration.

How is shaft deflection calculated?

The simple basis of this method is that the change in slope between two points Δθ = Δx. (M/EI) …. Δx being the distance betwen the points. The resulting change in deflection is clearly Δθ.

Is deflection the same as displacement?

Displacement is a vector quantity used to measure the position of a body due to external actions both rotational or translational applied to it. 2. Deflection is a scalar quantity used to measure the change in shape of a body due to rotational forces only (Moment/torsion).

How is mid span deflection calculated?

In practice it is the maximum deflection that is of interest and common sense would say that for this example this occurs at mid-span and can be calculated by substituting x=L/2=2.5m into equation 6 above.

Can solidworks calculate force?

In the PropertyManager, under Options select Reaction force. You can also click Results Advisor > List Result Force (Simulation CommandManager). Reaction forces are not calculated for rigid bodies.

How do I create a motion analysis in Solidworks?

You may right-click on the Motion Study tab to Create New Motion Studies. At the left upper corner side of the the MotionManager toolbar, pull-down and select Motion Analysis for the Type of Study.

How do you plot motor torque in Solidworks?

Plotting Torques

1. From a Motion Analysis study, click Results and Plots. …
2. In the PropertyManager, under Result, for Category, select Forces.
3. For Subcategory and its corresponding features, select from the following: …
4. For Select result component, select an option: …
5. Select the Plot Results options you require, and click .