How do you make a helix thread in Solidworks?

How do I create a thread in Helix solidworks?

How to model a Thread in SOLIDWORKS…

1. Create a plane at the point that you want the thread to start.
2. Sketch a circle that defines the starting diameter of the threads helical profile.
3. Add in a helix Insert > Curve > Helix/Spiral.
4. Create a plane at the end point of the helix.

How do I create a thread in Solidworks 2020?

Creating a Cut Thread

1. Open a model with a cylindrical part and click Insert > Features > Thread .
2. In the graphics area, select a circular edge.
3. In the PropertyManager, under Specification, set values for the following: …
4. For Thread method, click Cut thread. …
5. Set the starting position of the Thread Location:

How do you show threads in Solidworks?

To do that, go to the Annotations tab and select ‘Model Items’. Then select a view and a ‘Destination view(s)’ section will appear with the desired view, and under ‘Annotations’ you will want to select the cosmetic thread icon (as shown in the picture below). Then you should be good to go!

How do you make a tapped hole in Solidworks?

Create a part, select a surface, and click Hole Wizard (Features toolbar) or Insert > Features > Hole > Wizard . You can also open the Hole Wizard Type PropertyManager from an assembly.

How do you create a thread in Solidworks 2014?

Inserting Cosmetic Threads

1. On a cylindrical feature (a boss, a cut, or a hole), select the circular edge where the thread begins. If the feature is a conical hole, select the major diameter. …
2. Click Cosmetic Thread. …
3. Set the properties in the Cosmetic Thread PropertyManager .
4. Click .

How do I create a thread in Solidworks 2021?

To create a cut thread:

1. Open a model with a cylindrical part and click Insert > Features > Thread .
2. In the graphics area, select a circular edge.
3. In the PropertyManager, under Specification, set values for the following: …
4. For Thread method, click Cut thread. …
5. Set the starting position of the Thread Location:

How do you create assembly in Solidworks?

Creating an Assembly from a Part

1. Click Make Assembly from Part/Assembly (Standard toolbar) or File > Make Assembly from Part. An assembly opens with the Insert Component PropertyManager active.
2. Click in the graphics area to add the part to the assembly. SOLIDWORKS makes the first component fixed.