How do I join an arc in AutoCAD?

How do you join a line and arc in AutoCAD 2007?

Select the source line. 3. Select the other lines to join to the source line and press ENTER.

…

Procedure: Converting an Arc to a Circle with the Join Command

1. On the Modify toolbar, click Join.
2. Select an arc.
3. Right-click and select Close on the shortcut menu.
4. The arc is converted to a circle.

What is the opposite of explode in AutoCAD?

What is reverse of explode in AutoCAD? The opposite of explode is still implode.

What is fuzz distance in AutoCAD?

The fuzz factor is the distance AutoCAD should look from an unattached endpoint for another object. … AutoCAD can extend one or both lines to fill the gap, or simply add a segment to fill the gap; it may even need to do both.

Why is AutoCAD not joining lines?

Causes: Objects have gaps or do not have connecting points because of different elevations. Use the UNITS command and increase the precision to maximum. Examining the lines, the Properties palette will show Start Z / End Z or Elevation values, potentially of a minute amount.

Which method will give a chamfered corner?

You can also hold down the Shift key before selecting the second object or line segment of a 2D polyline to extend or trim the selected objects to form a sharp corner. While Shift is held down, a temporary value of zero is assigned to the current chamfer distance and angle values.

What is a Pedit?

Common uses for PEDIT include joining 2D polylines, converting lines and arcs into 2D polylines, and converting polylines into curves that approximate B-splines (spline-fit polylines). Different prompts are displayed, depending on the type of object you select to edit.

How do you use the Arc command?

Menu: Draw > Arc. To create an arc, you can specify combinations of center, endpoint, start point, radius, angle, chord length, and direction values. Arcs are drawn in a counterclockwise direction by default. Hold down the Ctrl key as you drag to draw in a clockwise direction.

What is the arc command?

The ARC command, followed by three mouse clicks on a drawing, draws an arc of defined width. The first point defines a point on a circle, the second its diameter. Entering the second coordinate reduces the circle to a semi-circle, while the right button alters the direction from first to second point.