Frequent question: Where is trim option in Catia v5?

What is TRIM command in Catia?

Trim: By the Trim option in Catia, a user can cut off two elements interchangeably. When we are going to trim, it is important to select the elements that we are going to cut off(They will appear in the trimmed elements field). The part of the element where we click is also retained by the system.

How do you cut parts in Catia?

Cutting the Part by the Sketch Plane

1. Double-click Sketch. 2 from the geometry. …
2. Move the sketch so that you can see the whole part.
3. Click Cut Part by Sketch Plane from the Visualization toolbar.

How do you trim solids in CATIA?

Split a solid with a solid

1. Select the Combine tool from the Intersect ribbon group.
2. Click the solid you want to cut.
3. Click the solid you want to cut with.
4. Mouse over the solid to see the regions created by the cut.
5. Click the region you want to delete. The regions you can delete are highlighted in red.

What is split trimming?

Trim: same as cutting but you can get the part you removed back by “dragging” the side of the clip. Split: you separate the clip in two parts. Both stay intact, they are just divided where you split them.

What’s the difference between trim cut and split?

In video editing, trimming is the process of either removing your clip’s front or tail portions, or increasing the length of the same. On the other hand, cutting is when you create sections out of a clip. You may use these sections for a different video or delete them altogether.

What are the different options available in Quick Trim command?

Q22: Explain the different options in the quick trim command? Break and rubber in remove part of the element, which is clicked. Break and rubber out, remove part of the element, which is not clicked. Break and keep keeps both parts of an element after breaking.

How do I cut an assembly in CATIA?

Reusing Assembly Design Splits



In this case, you just need to select the existing assembly split, click the Assembly Split icon and then select a face. Only the Assembly Features Definition dialog box appears to let you determine the parts of interest.