Frequent question: How do you select a section view in Solidworks?

How do I view sections in Solidworks?

(View toolbar) or View > Display > Section View.

…

Section Views in Models

1. Select bodies or components to include in or exclude from section views.
2. Toggle the view off and on. …
3. Show or hide a section cap. …
4. Select the faces, edges, and vertices created by a section view.

How do you change the section view in Solidworks?

To edit existing section views with Section View Assist: Right-click on an existing section view or its cutting line and click Edit Cutting Line. For some complex section views created with SOLIDWORKS 2013, you must select an insertion point before you can modify them. On the Section view pop-up, click an offset.

How do you do a section view in assembly in Solidworks?

To create a section view:

1. In a part or assembly document, click Section View. (View toolbar) or View > Display > Section View.
2. In the Section View PropertyManager, under Section 1, set the properties.
3. To section the model with additional planes or faces, select Section 2 and Section 3 and set the properties. …
4. Click .

What is a partial section view?

Partial section. Creates a section view that is limited by the length of the section line if the line does not span the entire view. Slice section. Shows only the faces cut by the section line.

How do I create a half section view in Solidworks?

To create a half section view:

1. Open install_dir sampleswhatsnewdrawingssectionview3. slddrw.
2. Click Section View. …
3. In the Section View PropertyManager, click Half Section.
4. In Half Section, click Topside Right .
5. Move the pointer. …
6. Drag the preview to the right and click to place the section view.

How do you move a section view arrow in Solidworks?

When you create a view letter attached to a view arrow, such as an auxiliary view or projected view, you can move the view letter. This is similar to moving the view letter in a section view. To move a view arrow letter: Select the arrow and drag the letter.

How do you identify a section view?

A sectional view or a section looks inside an object. Sections are used to clarify the interior construction of a part that cannot be clearly described by hidden lines in exterior views. By taking an imaginary cut through the object and removing a portion, the inside features may be seen more clearly.

How are section lines shown?

Section lines are very light. When sketching an object or part that requires a sectional view, they are drawn by eye at an angle of approximately 45 degrees, and are spaced about 1/8” apart. Since they are used to set off a section, they must be drawn with care.

What are the 7 types of section views?

There are a number of different types of sectional views that can be drawn. A few of the more common ones are: full sections, half sections, broken sections, rotated or revolved sections, removed sections, offset sections, and assembly sections.