Frequent question: How do you chamfer a thread in Solidworks?

How do you chamfer a thread?

To determine the longest chamfer for blind holes, subtract the full thread length required plus one pitch from the drill depth. The extra pitch enables clearance at the bottom of the hole for spindle over-spin and chips. Then divide this figure by the number of threads per inch (TPI).

How do you chamfer in Solidworks 2020?

To insert chamfer dimensions into a drawing:

1. Click Chamfer Dimension. on the Dimensions/Relations toolbar or click Tools > Dimensions > Chamfer. …
2. Select the chamfered edge, select one of the lead-in edges, then click in the graphics area to place the dimension. You must select the chamfered edge first. …
3. Click .

How do I choose a chamfer size?

Types of chamfers

1. The most common way to spec a chamfer is by giving its leg length size and the chamfer angle. …
2. Occasionally, a chamfer will be specified as being measured as a face width. …
3. If a chamfer is called out as a face width, then it is to be measured along the hypotenuse of the chamfer.

How do you make threaded rods in Solidworks?

Creating a Cut Thread

1. Open a part file. The diameter of the cylinder is 6mm. …
2. Click Insert > Features > Thread .
3. In the graphics area, select the top edge of the cylinder.
4. In the PropertyManager, under Specification: …
5. Under Thread Location: …
6. Under End Condition, click Maintain Thread Length. …
7. Click .

What is a thread undercut?

On turned parts an undercut is also known as a neck or “relief groove”. They are often used at the end of the threaded portion of a shaft or screw to provide clearance for the cutting tool, and also referred to as thread relief in this context.

How do you chamfer a cylinder in Solidworks?

To create a chamfer:

1. Click Chamfer. on the Features toolbar, or click Insert > Features > Chamfer.
2. Under Chamfer Parameters: Select an entity in the graphics area for Edges and Faces or Vertex . Select one of the following: …
3. Click .

Can you do a variable chamfer in Solidworks?

Click Chamfer (Features toolbar) or Insert > Features > Chamfer. Under Chamfer Parameters, select an item and set parameters. Some fields that accept numeric input allow you to create an equation by entering = (equal sign) and selecting global variables, functions, and file properties from a list.