Best answer: How do I change the orientation of CATIA?

How do I change the view in Catia Drafting?

Right-click on each projection view and select Update selection in the contextual menu to update the view according to the new reference plane. Or right click on Drawing1 and select Update selection in the contextual menu. The right, left, bottom, top and auxiliary views are updated, as well as the detail view.

How do I change the isometric view in Catia?

Changing the View Properties

1. Right-click the isometric view and select Properties .
2. On the View tab, check 3D Colors in the Dress-up area.
3. In the Generation Mode area, select Raster from the View generation mode drop-down list.
4. Click the Options button. …
5. Select Shading with edges from the Mode drop-down list.

How do I make axis visible in Catia?

As an alternative, you can right-click the absolute axis or one of its sub-elements and select Hide/Show. To restore the view, just select the hidden element and click Hide/Show again.

How do I enable axis in Catia?

Go to: Tools > Options > Infrastructure > Part Infrastructure > Display and look under ‘Display In Geometry Area’ To adjust the size, control the slider labelled ‘Axis system display size (in mm)’ The Axis System display can vary between 1mm – 100mm.

How do I change the active view in drafting?

Right-click the view to be set active. The contextual menu appears. 2. Select Activate View from the displayed contextual menu.

How do you change the isometric view?

To change the orientation of a section or aligned section view to isometric: Right-click a section or aligned section view and select Isometric Section View. To remove the isometric orientation, right-click the view and select Remove Isometric View.

How do you draft an isometric view?

Using the ruler, draw a vertical line on the page, and mark three equally spaced points along it. Draw a horizontal line through the lowest point, and using the protractor, mark out a 30 degree angle up from the line on either side. Draw a line back through the lowest point from the 30 degree angle on each side.

How do you select an isometric view?

You can now select isometric plane for your drawing by pressing the F5 key. The three Isoplanes available for selection are Isoplane top, right and left. Press F5 key to activate Isoplane top and then select line command and click anywhere in the drawing area to start your line.