Question: What are the different views in SOLIDWORKS?

What is model view in SolidWorks?

Model View creates a single view based on a predefined view orientation. The Model View PropertyManager appears when you create a new drawing, or when you insert a model view into a drawing document.

What are the standard 3d view in SolidWorks?

The Standard 3 View option under Insert > Drawing View creates three related default orthographic (front, right, left, top, bottom, and back) views of a part or assembly displayed at the same time. The view orientations used are based on the orientations (Front, Right, and Top) in the part or assembly.

What are the typical standard drawing views?

The most common way to communicate all the information is by using three different views in a multiview drawing: Front view. Top view. Side view.

How do you make an isometric view in Solidworks?

To change the orientation of a section or aligned section view to isometric: Right-click a section or aligned section view and select Isometric Section View. To remove the isometric orientation, right-click the view and select Remove Isometric View.

How do I view sections in Solidworks?

To create a section view:

1. In a part or assembly document, click Section View. …
2. In the Section View PropertyManager, under Section Method, select one of the following: …
3. In the Section View PropertyManager, under Section Option, select how the section offset is calculated: …
4. Under Section 1, select a plane.

What are the three standard views we show on your drawings?

Although six different sides can be drawn, usually three views of a drawing give enough information to make a three-dimensional object. These views are known as front view, top view and end view.

What are the standard three views in a drawing?

Standard views typically include the 3 principle views – front, top, right side. There are several methods for generating the standard drawing views.

What is 3D view drawing?

3D drawing view mode lets you rotate a drawing view out of its plane so you can see components or edges obscured by other entities. The 3D drawing view causes temporary changes to a drawing view. It is used to make geometry selection in a drawing view easier.

What is a sectional view?

A sectional view represents the part of an object remaining after a portion is assumed to have been cut and removed. The exposed cut surface is then indicated by section lines. Hidden features behind the cutting plane are omitted, unless required for dimensioning or for definition of the part.

What is front view?

A front view is a projection view obtained by drawing perpendiculars from all points on the edges of the part to the plane of projection. The plane of projection upon which the front view is projected is called the frontal plane.

What are the three most common views in a multiview drawing?

Although six different sides can be drawn, usually three views of a drawing give enough information to make a three-dimensional object. These views are known as front view, top view and end view.

What does 1 typ mean in Solidworks?

TYP means ‘Other features share the same characteristic. For example, if the drawing shows 8 holes on a bolt circle, and just one is dimensioned, with “TYP” or “(TYP)” following the dimension label, it means that that hole is typical of all 8 holes; in other words, it means that the other 7 holes are that size also.