How do you sweep a circle in Solidworks?

How do you sweep a shape in Solidworks?

To create a sweep: Sketch a closed, non-intersecting profile on a plane or a face.

…

Click one of the following:

1. Swept Boss/Base on the Features toolbar or Insert > Boss/Base > Sweep.
2. Swept Cut on the Features toolbar or Insert > Cut > Sweep.
3. Swept Surface on the Surfaces toolbar or Insert > Surface > Sweep.

How do I use surface sweep in Solidworks?

Click Swept Surface (Surfaces toolbar) or Insert > Surface > Sweep. Set the PropertyManager options. Click OK .

How do you do a sweep?

Create a Sweep

1. In the Family Editor, on the Create tab Forms panel, do one of the following. …
2. Specify the sweep path: …
3. On the Mode panel, click (Finish Edit Mode).
4. Load or sketch a profile. …
5. On the Properties palette, specify the sweep properties. …
6. On the Mode panel, click (Finish Edit Mode).

What is sweep command in Solidworks?

SWEEP is the one feature in Solidworks that helps sweep a closed profile along a closed or open path. In this session, we are going to use a simple 3D object as an exercise to demonstrate the use of the SWEEP command in Solidworks.

How do you do a sweep in Solidworks assembly?

Click Assembly Features (Assembly tab on the CommandManager) and click Swept Cut , or click Insert > Assembly Feature > Cut > Sweep . Set options as needed in the Swept Cut PropertyManager. Under Feature Scope, specify which components you want the feature to affect.

How do you use the lofted boss base in SolidWorks?

How to create a Lofted Boss/Base in SolidWorks:

1. Sketch your profiles. A minimum of two are required but a higher number of profiles allows you to create more complex shapes. …
2. Select the Loft Feature, then choose the profiles in order. …
3. Adjust the Constraints and options as required.

What is swept surface?

Sweep Surfaces are surfaces that are generated from a section curve positioned along a path. Various Sweep types are available to extend the sweep definition as follows: Sweep by Two Guide Curves is defined as moving and adjusting a section curve along two guide curves.

How do you cut a surface in Solidworks?

Click Cut With Surface on the Features toolbar, or click Insert > Cut > With Surface. In the PropertyManager, under Surface Cut Parameters, select the surface or plane to use to cut the solid bodies. Examine the preview. If necessary, click Flip cut to reverse the direction of the cut.

How do you round a point in Solidworks?

In order to round off the corner edges of the rectangle use the Fillet tool also found on the feature tab.

1. Click on the fillet tool.
2. Select the corner edges you want to round off.
3. Define the radius of the fillet (0.25 in)
4. Click the green check mark.