How do you add a bolt to SOLIDWORKS assembly?

How do you add a bolt and nut in Solidworks?

To add nuts and washers at the end of a bolt:

1. Under Series Components, select a component in Add to Bottom Stack. The component is added to Bottom Stack .
2. Select more components as needed. Add washers first, and the nut last. The hardware appears in order from the bolted surface toward the end of the bolt.

How do I add parts to assembly in Solidworks?

Right-click the component and click Insert Into Assembly. You can populate one or more holes in the assembly by preselecting the circular edges of the holes and then using Insert Into Assembly. If you do not preselect a hole, the part is placed at the assembly origin.

How do you add threads in SolidWorks?

Start by creating a cylindrical extrusion or cylindrical hole, much like the initial steps to of making a cosmetic thread. The feature size should be the same as the nominal thread diameter. From there, select the starting edge. Then, click “Insert” then “Feature” and “Thread.” This will automatically create a thread.

How do you add threads in SolidWorks 2020?

To create a cut thread:

1. Open a model with a cylindrical part and click Insert > Features > Thread .
2. In the graphics area, select a circular edge.
3. In the PropertyManager, under Specification, set values for the following: …
4. For Thread method, click Cut thread. …
5. Set the starting position of the Thread Location:

What is a foundation bolt in Solidworks simulation?

SolidWorks Simulation can also simulate the behavior of a foundation bolt (or grounded bolt) that attaches a part to a virtual ground (which is infinitely stiff).

How do I add parts to assembly?

To create a part within an assembly: Click New Part (Assembly toolbar) or Insert > Component > New Part. For externally saved parts, type a name for the new part in the Save As dialog box and click Save.

How do you add threads to a screw in Solidworks?

Creating a Cut Thread

1. Open a part file. The diameter of the cylinder is 6mm. …
2. Click Insert > Features > Thread .
3. In the graphics area, select the top edge of the cylinder.
4. In the PropertyManager, under Specification: …
5. Under Thread Location: …
6. Under End Condition, click Maintain Thread Length. …
7. Click .