Your question: How do you use chamfer dimension in SolidWorks?

How do you indicate the dimension of chamfer?

D1 X D2 – You specify the edge to be chamfered, and then you edit two linear dimensions. The chamfer is created with the ends of the chamfer at the distances specified from the edge. Angle X D – You specify the edge to be chamfered, and then enter a value for an angle and a linear dimension.

How do you inspect a chamfer?

Types of chamfers

1. The most common way to spec a chamfer is by giving its leg length size and the chamfer angle. …
2. Occasionally, a chamfer will be specified as being measured as a face width. …
3. If a chamfer is called out as a face width, then it is to be measured along the hypotenuse of the chamfer.

How do you dimension asymmetric chamfer?

Procedure

1. Select the appropriate Filters and Attributes options.
2. Pick the chamfer to be dimensioned.
3. Identify the application point of the chamfer dimension and confirm by clicking the left mouse button.
4. Continue to create as many Chamfer dimensions as you need by sequentially selecting all the required chamfers.

How do you annotate a chamfer drawing?

Add a chamfer note

1. On the ribbon, click Annotate tab Feature Notes panel Chamfer .
2. On the drawing, select the chamfered model or sketch edge.
3. Select a reference line or edge from the model or sketch that shares endpoints or intersects with the chamfer. …
4. Click to place the chamfer note.

What is the difference between a fillet and a chamfer?

Fillets describe rounded corners of a design (or part) that help to reduce stresses and prevent rapid deformation at the corners of the part. In contrast, chamfers are sloped or angled edges (usually at 45° or 60° ) of a design or part.

How is chamfer depth calculated?

You simply divide the diameter of the spot-drilled hole. If you have drilled a 0.25″ diameter hole and want a 0.031″ chamfer on the hole, the diameter to be spot drilled will be 0.312″. The spot-drill depth, 0.156″ is half of this.

What is a chamfering tool?

A Chamfer or deburring tool is used to create a bevel or furrow on the end of a bolt.

What are chamfered edges?

Chamfered Edge / Beveled Edges



A chamfer is a beveled edge connecting two surfaces. If the surfaces are at right angles, the chamfer will typically be symmetrical at 45 degrees.

How do you dimension a chamfer Fusion 360?

you can draw a rectangle at desired corner and after that a line to create chamfer, then trim (delete) other lines. Another way is to draw a line where you want the chamfer to be placed, then use sketch dimension to position it exactly where you want.

How do you give chamfer dimension in Catia?

Go to Tools > Options > Mechanical Design > Drafting > Dimensions tab and make sure the Detect chamfer check box is selected. Click Chamfer Dimensions in the Dimensioning toolbar ( Dimensions sub-toolbar).