Quick Answer: What is a connection point solidworks?

What is a connection point?

A connection point is the interface exposed by the source. By exposing a connection point, a source allows sinks to establish connections to itself (the source). Through the connection point mechanism (the IConnectionPoint interface), a pointer to the sink interface is passed to the source object.

How do you connect points in Solidworks?

To add a connection point:

1. Create a sketch point to use for locating the connection point. The location of the connection point defines the end of the adjoining routing segment; that is, the point where the pipe, tube or wiring begins or ends.
2. Click Create Connection Point. …
3. Edit properties in the PropertyManager.
4. Click .

What is routing points in Solidworks?

A route point is a point in a fitting (flange, elbow, electrical connector, and so on) that is used to position the fitting at an intersection or endpoint in the 3D sketch. Connection Point PropertyManager.

How do you create a routing point in Solidworks?

To add a route point:

1. Click Create Route Point. …
2. Under Selections in the PropertyManager, for Select sketch point or vertex : …
3. Find or create a sketch point to use for positioning the fitting at an intersection or end point of the route, or at a split point on the route.
4. Click .

What is another term for connection point?

1 alliance, association, attachment, coupling, fastening, junction, link, tie, union.

What is difference between point-to-point and multipoint connection?

The main difference between point-to-point and multipoint connection is that in a point-to-point connection the link is only between two devices i.e. a sender and a receiver. On the other hand, in a multipoint connection, the link is between a sender and multiple receivers.

How do you join lines in Solidworks?

You can apply connection lines automatically when you add center marks to a drawing view at the time of creation. In a drawing, click Tools > Options > Document Properties > Detailing , and under Auto insert on view creation, select Connection lines to hole patterns with center marks.