How do you sweep a boss base in Solidworks?

What is swept boss Base Command in Solidworks?

Creates a sweep by moving a 2D profile along a 2D or 3D sketch path. Sets the profile (section) used to create the sweep. Select the profile in the graphics area or FeatureManager design tree. You can select faces, edges, and curves directly from models as sweep profiles.

What is sweep command in Solidworks?

SWEEP is the one feature in Solidworks that helps sweep a closed profile along a closed or open path. In this session, we are going to use a simple 3D object as an exercise to demonstrate the use of the SWEEP command in Solidworks.

What is required to create a solid using the swept boss base tool?

There are two main requirements to create a Swept Boss or Base: A closed profile and a path. This first example will show how to create a sweep using a circular profile and an open relatively linear path. Figure 1, below, shows the profile drawn on the front plane and the sweep path drawn on the top plane.

How do you use the lofted boss base in Solidworks?

How to create a Lofted Boss/Base in SolidWorks:

1. Sketch your profiles. A minimum of two are required but a higher number of profiles allows you to create more complex shapes. …
2. Select the Loft Feature, then choose the profiles in order. …
3. Adjust the Constraints and options as required.

How do you sweep in Assembly in Solidworks?

Click Assembly Features (Assembly tab on the CommandManager) and click Swept Cut , or click Insert > Assembly Feature > Cut > Sweep . Set options as needed in the Swept Cut PropertyManager. Under Feature Scope, specify which components you want the feature to affect.

How do you swept cut in Solidworks?

Swept Cut PropertyManager

1. Open a part that has either a closed profile sketch and a sketch path, or a part with a sketch line, edge or curve on the model that you can specify as a path. For a solid profile, open a part that has a tool body as the profile and a sketch path to follow.
2. Click Swept Cut (Features toolbar).

How do you use the swept boss base?

How to use Swept Boss/Base Feature – SolidWorks Tutorial

1. Click New. …
2. Click Top Plane and click on Sketch.
3. Click Circle and sketch a circle origin as it center. …
4. Exit Sketch.
5. Take a plane normal to spline end (or Click on Front Plane and click Sketch.)
6. Click on View Orientation-Normal To.

How do you do a sweep?

Create a Sweep

1. In the Family Editor, on the Create tab Forms panel, do one of the following. …
2. Specify the sweep path: …
3. On the Mode panel, click (Finish Edit Mode).
4. Load or sketch a profile. …
5. On the Properties palette, specify the sweep properties. …
6. On the Mode panel, click (Finish Edit Mode).

How do you sweep a tube in SolidWorks?

To create a circular profile sweep:

1. In a part, click Insert > Cut > Sweep to cut a tube into the part.
2. In the PropertyManager, under Profile and Path, click Circular Profile.
3. In the graphics area, select a curved edge for Path. …
4. Click . …
5. Click Insert > Boss/Base > Sweep to add the solid rod.

Can you sweep a body in SolidWorks?

For cut sweeps only, you create a solid sweep by moving a tool body along a path. The path must be tangent within itself (no sharp corners) and begin at a point on or within the tool body profile.

…

Sweeps.