How do you make threaded rods in Solidworks?

How do you create threads in Solidworks?

Start by creating a cylindrical extrusion or cylindrical hole, much like the initial steps to of making a cosmetic thread. The feature size should be the same as the nominal thread diameter. From there, select the starting edge. Then, click “Insert” then “Feature” and “Thread.” This will automatically create a thread.

How do I create a thread in Solidworks 2020?

Creating a Cut Thread

1. Open a model with a cylindrical part and click Insert > Features > Thread .
2. In the graphics area, select a circular edge.
3. In the PropertyManager, under Specification, set values for the following: …
4. For Thread method, click Cut thread. …
5. Set the starting position of the Thread Location:

How do you make a rod in Solidworks?

Creating Rods and Tubes with a Circular Profile

1. Open install_dir sampleswhatsnewpartssweep_part_1. …
2. Click Insert > Cut > Sweep to cut a tube into the part.
3. In the PropertyManager, under Profile and Path, click Circular Profile.
4. In the graphics area, select a curved edge for Path. …
5. Click .

How do I create a thread in Solidworks 2019?

To create a cut thread:

1. Open a model with a cylindrical part and click Insert > Features > Thread .
2. In the graphics area, select a circular edge.
3. In the PropertyManager, under Specification, set values for the following: …
4. For Thread method, click Cut thread. …
5. Set the starting position of the Thread Location:

How do I create a thread in Solidworks 2021?

To create a cut thread:

1. Open a model with a cylindrical part and click Insert > Features > Thread .
2. In the graphics area, select a circular edge.
3. In the PropertyManager, under Specification, set values for the following: …
4. For Thread method, click Cut thread. …
5. Set the starting position of the Thread Location:

How do I use the thread tool in Solidworks?

The Thread Tool can then be found underneath the Hole Wizard Tool on the Features tab of the Command Manager, or in Insert>Features>Thread. Once the Thread Tool is selected the location of the thread needs to be specified by selecting a circular edge. Then the thread specification should be set.