How do you cut a hole in a countertop in Revit?

How do you cut a hole in a counter in Revit?

Upon placing the sink to top of the countertop, use Cut command on the Modify menu to cut the hole. You can also nest the sink to the countertop family as well.

How do you cut a void counter in Revit?

Cutting with voids in families when loaded

1. Open the Revit family with unattached voids and click Create tab Properties panel Family Category and Parameters.
2. In the Family Category and Parameters dialog, select Cut With Voids when Loaded and click OK.
3. Load the family into the project and place it.

How do you cut a hole in an object in Revit?

Load the family into the project and place it. Click Modify tab Geometry panel Cut drop-down (Cut Geometry). Select the object to be cut. Select the instance with which to cut.

How do you make a hole in the ceiling in Revit?

Cut an Opening in a Floor, Roof, or Ceiling

1. Click By Face or Vertical. Where is it? Architecture tab Opening panel. Structure tab Opening panel. …
2. If you chose By Face, select a face in the floor, ceiling, or roof. If you chose Vertical, select the entire element. Selected face for opening by face. …
3. Click Finish Opening.

How do you cut out a void extrusion in Revit?

Solution:

1. Edit the in place wall.
2. Create a new void extrusion that will define the opening.
3. Use the “Cut” tool and select the void geometry.
4. Finish the solid edition.

How do you cut in Revit?

Load the family into the project and place it. Click Modify tab Geometry panel Cut drop-down (Cut Geometry). Select the object to be cut. Select the instance with which to cut.

How do you cut a curtain wall in Revit?

Go to Modify tab > Geometry panel > Cut, activate the Multiple Cut option in the options bar and select the “opening” object first, then select the panels and mullions to be cut.

How do you trim an extrusion in Revit?

Choose “Void extrusion” to create an In-place family roof. Pick the line on the base of the inside edge of the roof to draw the void in a section view. The “cut geometry” command can be used to select the roof over the void. To execute the cut, click “Finish” after that.