How do I select a parent view in Fusion 360?

How do I change the view on Fusion 360?

Solution: To change the default orientation of the Home view: Right-click the Home button above the view cube. Select “Set Current View as Home”

How do you get to the section view in Fusion 360?

The Section Analysis tool creates a section of a model and allows to see inside it:

1. Choose Inspect -> Section Analysis.
2. Select a face or plane for the section view to start on.
3. Use the manipulators to position the section view.
4. Click OK. Fusion will add the section view to the Analysis folder in the browser tree.

What is a base view in Fusion 360?

When you create a drawing from the Fusion 360 modeling environment, the system automatically launches a new tab of the Drawing workspace and generates a 2D projection of the components you select. The drawing view generated is referred to as a Base View.

Where would you create a projected view in Fusion 360?

From the Create Toolbar, select Projected View. Click the base view to select it as the parent view from which the projected views will be created and associated.

How do you change XYZ in Fusion 360?

Click the bubble with either the account name initials or account picture in the top right corner of Fusion 360. Select Preferences. In the General preferences tab is an option called “Default Modeling Orientation”. Use this dropdown to select Z up instead of Y up.

Where is mesh to BRep?

Mesh to BRep is only available in Direct Modeling Mode. To enter direct modeling mode, right-click on the Fusion 360 Browser > select “Do Not Capture Design History.” A warning dialog will appear.

What is a section view?

What is a section view? A sectional view or a section looks inside an object. Sections are used to clarify the interior construction of a part that cannot be clearly described by hidden lines in exterior views.

What is an offset section view?

An offset section view is generated by offsetting (bending) the cutting plane to show features that are not in a straight line.

What is Zebra analysis?

The zebra analysis tool projects stripes onto a surface so that you can inspect the continuity between surfaces. Surface continuity is a measure of how smoothly two surfaces flow into each other.

In what ways can you create a standard 3 view?

The Standard 3 View option under Insert > Drawing View creates three related default orthographic (front, right, left, top, bottom, and back) views of a part or assembly displayed at the same time. The view orientations used are based on the orientations (Front, Right, and Top) in the part or assembly.

What does the concentric constraint do to sketch geometry in Fusion 360?

The next constraint is “concentric,” which forces circular sketch elements, such as circles and arcs, to share a common center point.

What is 3rd angle projection?

3rd Angle project is where the 3D object is seen to be in the 3rd quadrant. It is positioned below and behind the viewing planes, the planes are transparent, and each view is pulled onto the plane closest to it. The front plane of projection is seen to be between the observer and the object.

What is a first angle projection?

In the first angle projection, the object is placed in the 1st quadrant. The object is positioned at the front of a vertical plane and top of the horizontal plane. First angle projection is widely used in India and European countries. The object is placed between the observer and projection planes.

What is the symbol of Third angle projection?

The third angle symbol is shown in Figure 1. It is represented by the circular top view of the cone with the right view of the cone to the right of it. In the right-side view, the narrow end of the cone is pointed towards the top view.