How do I cut models in Catia?

How do I cut a section in Catia?

Creating 3D Section Cuts

1. Select Insert > Sectioning from the menu bar, or click Sectioning in the DMU Space Analysis toolbar and create a section plane. …
2. In the Definition tab, click Volume Cut to obtain a section cut:

How do you split a solid in Catia v5?

CATPart document.

1. Click Split . The Split Definition dialog box is displayed.
2. Select Surface. 1 as the splitting surface. This surface intersects only one pad. …
3. Click OK . Material has been removed, but only one pad is split. The other one is unchanged because the surface did not intersect it.

How do I cut a view in Catia?

Creating an Offset Section View / Cut

1. In the Drawing window, click Offset Section View in the Views toolbar ( Sections sub-toolbar). If desired, you can also click Offset Section Cut . …
2. Create the first point of the profile. …
3. Choose the constraint. …
4. Double-click to end the cutting profile creation.

What is the difference between split and trim in Catia?

Split versus Trim



The main difference between these two commands is that Split is only cutting specific surfaces while Trim will cut all surfaces involved in the operation.

How do you take sections in Catia Assembly?

To gain access to the Sectioning tool, CATIA users will need to add the Sectioning tool into their 3DCS workbench. With a model open, start the Sectioning tool. The Sectioning Definition will appear. In the Positioning tab, the user can specify the section plane direction in either X, Y, Z directions.

How do I use section view in Catia?

Creating a Section View

1. Click the Drawing window, and click the Offset Section View icon. from the Views toolbar (Sections subtoolbar).
2. Select the holes and points required for sketching the callout on the view. …
3. Double-click to end the cutting profile creation.

How do I cut in Catia v5?

Cutting the Part by the Sketch Plane

1. Double-click Sketch. 2 from the geometry. …
2. Move the sketch so that you can see the whole part.
3. Click Cut Part by Sketch Plane from the Visualization toolbar.

What is removed section?

A section removed from its normal projected position in the standard arrangement of views is called a “removed” section. Such sections are labeled SECTION A-A, SECTION B-B, etc., corresponding to the letter designation at the ends of the cutting plane line.

How do I get the space analysis toolbar in Catia?

Procedure:

1. Go to Tools -> Customize,
2. Select the Tool-bars tab.
3. Select New..,
4. select Assembly Design workbench (left window),
5. and select Space Analysis (right window).