How do you snap Onshape?

What is fastened mate Onshape?

This functionality is available on Onshape’s browser, iOS, and Android platforms. Mate two entities and remove all degrees of freedom between them. Mate two entities and remove all degrees of freedom between them.

How do you mate Onshape?

The Mate type specifies the movement behavior. Mates in Onshape are different than mates in traditional CAD systems.

…

More tips for visualizing Mates:

1. Select a part, right-click for the context menu and select Show mates.
2. Hover over a Mate, right-click for the context menu where you can take action on the Mate.

How do you use a coincident Onshape?

To start, select the entities that you wish to make coincident. In this case we’re going to select the lower left corner of the first rectangle and the top right corner of the second rectangle. Next, select the Coincident tool from the sketch toolbar.

Do assemblies have reference planes in Onshape?

@james_close We do not allow planes in the Assembly however you can use mate connectors which can be added to the assembly origin. Hi, Thanks for the comment. You allow Parts, Sketches and Surfaces defined in a Part Studio to be Inserted to an Assembly.

What is a mate connector?

Mate connectors are local coordinate system entities located on or between parts or surfaces and used within a mate to locate and orient part or surface instances with respect to each other. You can also use mate connectors to create planes.

What does cylindrical mate do?

Mate two entities allowing translational movement along the Z axis and rotational movement about the Z axis (Tz, Rz).

How do you show constraints on Onshape?

With a sketch open, hover over a sketch entity, like a line or arc, to see the constraints for that entity. As you move the mouse to hover over entities, constraints will appear only for the highlighted entity. To keep all constraints visible, use the Shift key as you move the mouse.

How do you define a sketch in Onshape?

Apply constraints to sketch entities

1. Click Sketch to select the Sketch tool in the toolbar.
2. Select a plane. …
3. Click. …
4. Click in the graphics area to set the center of the circle.
5. Move the cursor away from the first point and click again to set the diameter of the circle.