How do you plot stress in Solidworks?

Can you do stress analysis in Solidworks?

SimulationXpress is included in every version of SOLIDWORKS and provides stress analysis on simple parts while you’re working. Functionally, it’s a software wizard built into SOLIDWORKS. SOLIDWORKS SimulationXpress guides you through defining fixtures, loads, and materials.

How do you show mesh on a stress plot in Solidworks?

After you create the mesh, and before you run the study, right-click a mesh quality plot and click Mesh Sectioning. To view a mesh sectioning plot superimposed on a result plot, right-click an active result plot and click Mesh Sectioning.

How do you show max and min stress in SOLIDWORKS Simulation?

Edit the Stress Plot definition and enable the option ‘Show plot on selected entities’. Either select face(s) or bodies/component(s) to show the stresses on just those regions. Then on the Chart Options tab, select the options ‘Show max annotation’ and ‘Show Min/Max range on shown parts only’.

What is stress plot?

The Stress Plot PropertyManager allows you to plot stress results for static, nonlinear, dynamic, and drop test studies. To display this PropertyManager, run a static, nonlinear, dynamic study, or drop test study. Right-click Results and select Define Stress Plot.

How do I mesh sections in Solidworks?

With the Mesh Section PropertyManager, you can view mesh elements inside the volume of parts. To open the Mesh Section PropertyManager, do one the following: Create a mesh, right-click a mesh quality plot, and click Mesh Sectioning. Right-click an active result plot and click Mesh Sectioning.

How do I read solidworks simulation results?

Displaying SOLIDWORKS Simulation Results in the Graphics Area

1. Open an assembly that has a simulation study saved with it.
2. Click the Static 1 tab.
3. In the Simulation Study tree, right click Static 1 and click Run.
4. Click the Model tab.
5. Click Simulation Display (View toolbar) or View > Display > Simulation Display .

How do you create a stress strain curve in Solidworks?

On the Properties tab, do the following:

1. Set Model Type to either Nonlinear Elastic, Plasticity – von Mises, or Plasticity – Tresca.
2. Select the desired Units.
3. Click Create Stress-Strain Curve. The Tables & Curves tab is active and Stress-Strain Curve is selected in Type.

What is stress vs strain?

Stress is the force applied to a material, divided by the material’s cross-sectional area. Strain is the deformation or displacement of material that results from an applied stress.

How do you show yield strength in Solidworks simulation?

The yield strength value is displayed at the bottom of the plot legend. When checked, the local coordinate system reference triad is displayed at the lower right corner of the graphics area. The triad is displayed only for plots where you define a reference plane, axis, or coordinate system.