Frequent question: How do you make a circular pattern in SolidWorks?

How do you make a circular pattern?

To create a circular pattern:

  1. Create one or more features to replicate.
  2. Click Circular Pattern (Features toolbar) or Insert > Pattern/Mirror > Circular Pattern.
  3. Set the PropertyManager options.
  4. Click .

How do you create a pattern in Solidworks?

To create a fill pattern, click Fill Pattern (Features toolbar) or Insert > Pattern/Mirror > Fill Pattern, set the PropertyManager options, and click . Parameters control the pattern layout. You can create a sheet metal perforation-style pattern, or a pattern of concentric shapes typically used to enhance aesthetics.

How do you mirror a circular pattern in Solidworks?

In a part model, click Circular Pattern (Features toolbar) or Insert > Pattern/Mirror > Circular Pattern.

How do I make a circular pattern in Inventor?

Select Circular Pattern from the Sketch panel or select the Circular Pattern button from the Sketch toolbar. (See Figure 2–15.) 9. Select the circle indicated as the geometry to array and the center of the large circle as the center of the array.

How do you annotate circular patterns in Solidworks?

Circular Note Pattern

  1. Select the note.
  2. In a drawing view, click Circular Note Pattern (Annotations toolbar) or Insert > Annotations > Circular Note Pattern .
  3. In the PropertyManager, under Parameters: …
  4. Click .
  5. After you create the pattern, you can edit the notes individually.
IT IS INTERESTING:  Question: How many grams is a rhino horn?

How do you make a hollow cylinder in Solidworks?

To Make a Hole Through the cylinder:

  1. Select the front face of the cylinder by clicking on the circumference. …
  2. Click Exit Sketch, then select the smaller circle by clicking on the circumference.
  3. Select Extrude Cut, and in the Property Manager that appears on the left of your screen, make D1 60mm.

How do you wrap a cylinder around a pattern in Solidworks?

Wrap

  1. Select the sketch you want to wrap from the FeatureManager design tree. …
  2. Click Wrap on the Features toolbar, or click Insert > Features > Wrap.
  3. In the PropertyManager, under Wrap Type: …
  4. If you select Emboss or Deboss , you can select a line, linear edge, or plane to set a Pull Direction . …
  5. Click OK .
Special Project