Frequent question: How do you cut in Revit 2021?

Where is the cut tool in Revit?

On the Modify ribbon, in the Geometry panel, click Cut Geometry. Revit prompts you to select the geometry to be cut. Click to select the wall. Then Revit prompts you to select the void geometry to cut.

How do you trim a solid in Revit?

Click Modify tab Geometry panel (Cut). Select the solid form to be cut. Select the cutting solid form. The solids cut accordingly.

Where is option in Revit 2021?

The Options Bar is located below the ribbon. It displays conditional tools dependent on the current tool or selected element. To move the Options Bar to the bottom of the Revit window (above the status bar), right-click the Options Bar, and click Dock at bottom.

How do you cut an object in Revit?

When selecting an element that needs to be trimmed to form the corner, make sure you click the part of the element to be retained. click Modify tab Modify panel Trim drop-down (Trim/Extend Single Element). Select the reference to use as a boundary. Then select the element to trim or extend.

How do you trim a spline in Revit?

Note: While you can’t use the Trim/Extend to corner command with Splines and you can’t modify a spline using the Trim/Extend (single element), you can modify a non-spline line using a spline line as the source i.e. start Trim/Extend command, select Spline first, and select non-spline line second (to trim/extend).

How do you trim an extrusion in Revit?

Choose “Void extrusion” to create an In-place family roof. Pick the line on the base of the inside edge of the roof to draw the void in a section view. The “cut geometry” command can be used to select the roof over the void. To execute the cut, click “Finish” after that.

How do I use options in Revit?

Setup a Design Option

1. On the Manage tab within Revit, select the Design Option button.
2. Select the New button under Design Option Set to create a new option set called “Option Set 1”. …
3. Select the New button under Option to create a new option called Option 2.
4. Close the Design Option dialog.

How do I remove a element from design in Revit?

Re: Removing Items from a Design Option

1. Select the elements (either by editing its design option or unchecking the option checkbox in the Option Bar).
2. Cut.
3. Edit the target option.
4. Paste Aligned | Same Place.