Best answer: How do you see which drawing is active in Catia?

How do you know which drawing view is active in CATIA?

What is the active view?

1. The active view has a red frame and it is underlined in the Drafting specification tree.
2. Non-active views have blue frames.
3. During view creation, the view to be created has a green frame until you click at the desired view location to validate the creation.

How do you change active view in Drafting?

You can update all views in a given sheet (or in a selection of sheets), by selecting and right-clicking the sheet(s) and then choosing Update Selection . You can also use the same method for a drawing: this will update all sheets (and therefore all views) in the drawing.

What is interactive Drafting in CATIA?

Interactive Drafting is a new generation CATIA product to address 2D design and drawing production requirements, It offers a highly productive, and intuitive, interactive drafting system.

How do you see which drawing view is active in drafting?

You can select a view, as shown on the left, by choosing the view name in the FeatureManager design tree. The active view, shown on the right, lets you create sketch geometry and annotations.

How do you rotate a view in Catia?

1- Open CATIA 2- Open new drawing 3- Create a circle ,Create center line for the circle 4- Click Rotate icon 5- Select the center line and then its center point 6- Input the angle value 45 deg 7- Check off Duplicate mode 8- Click OK .

Where is sketch analysis Catia?

Select Tools > Sketch Analysis from the menu bar. Or alternatively, click Sketch Analysis in the Tools toolbar ( 2D Analysis Tools sub-toolbar). The Sketch Analysis dialog box appears. It contains three tabs: Geometry , Projections / Intersections and Diagnostic .

How do I close a sketch in Catia v5?

In a 2D part sketch, right-click one section of the geometry you want to close. Select the start or end of the sketch geometry you want to close. Continue selections until the loop is closed.

How do I change the draft view in Catia?

Right-click the view and select Isometric view object > Modify Projection plane . Click on the part. The isometric view with the new reference plane is previewed in the drawing. The isometric view is modified in the drawing.

How do I change my origin point in Catia?

RE: Changing Point of Origin within CatiaV5



I take the compass and I place it at a convenient face I want to be my new part origin. Right click on the compass red dot and choose EDIT. Be sure your main body is active. Put all positions and angles at 0.