Best answer: How do I view a 3D section in Revit?

To add a center line select the Centerline tool from Centerlines panel of Annotate tab and click on the two lines. The center line will be automatically added in between the selected lines. If the lines are intersecting then the center line will pass through the angle bisector of the lines as shown in the image below.

How do I view sections in Revit?

To open the section view, double-click the section header, or select the section view from the Sections grouping of the Project Browser. The section view changes when the design changes or the section line is moved.

How do you break a section in Revit?

Break a Section Line

1. Click the break control ( ) and adjust the length of the section line segments.
2. To rejoin the section line, click the break control again. Note: A break in a section line is view-specific. It affects the display of the section only in the view where the break was made.

How do I section a part in Creo?

To section a part using faces,

1. Position two or more parts in a way that they intersect each other.
2. Click Modeling and then, in the Model group, click the arrow next to Remove.
3. Click Section. …
4. Specify the part or parts to be sectioned.
5. Click Faces.
6. Specify the face or faces to section the part or parts.

How do you see the cross section in Creo?

You can display and control the cross-hatching of these 3D cross sections within drawings.

1. Open a drawing.
2. Click Layout > General.
3. Click a location to place the general view. …
4. Click Sections. …
5. Select the required cross section and click Apply. …
6. To display crosshatching in the view, click the Show X-Hatching check box.

How do you switch between 2d and 3D in Revit?

Shift-tab also cycles through open Revit views. If you only have a plan view and a 3D view open, then shift-tab will quickly take you from one view to the next.