Which results are available for a bolt connector in Solidworks?

What is a foundation bolt in SolidWorks simulation?

SolidWorks Simulation can also simulate the behavior of a foundation bolt (or grounded bolt) that attaches a part to a virtual ground (which is infinitely stiff).

What are the benefits of distributed coupling for Pins & bolts?

The addition of distributed coupling for bolts and pins allows the head, nut, or shaft contacting nodes to deform independently, better simulating the actual behavior of your assemblies. This means more realistic stresses and displacements near connectors, and fewer artificial stress hot spots.

What is a bolt connector?

Connector – Bolt



A Bolt can connect two components, multiple components, or a component and the ground. You can define bolts through a mixed stack of solids, shells, and sheet metal bodies. You can also define a bolt by selecting entities of the same component.

What is bolt preload?

Preload is the tension created in a fastener when it is tightened. This tensile force in the bolt creates a compressive force in the bolted joint known as clamp force. For practical purposes, the clamp force in an unloaded bolted joint is assumed to be equal and opposite of the preload.

Which of the following would a bolt connector be useful for?

Which of the following would a Bolt Connector be useful for? To replace bolts, washers, and nuts with a Simulation defined connection to simulate actual bolts, washers, and nuts for an analysis.

IT IS INTERESTING:  Can I run Ansys on Mac?

What is bonded contact in SolidWorks?

The program bonds the Set 1 and Set 2 (source and target) entities defined in the Contact Set PropertyManager. Bonded entities behave as if they were welded. This option is available for static, nonlinear, frequency, buckling, and thermal studies. The mesh does not have to be compatible.

What is elastic support in SolidWorks simulation?

An Elastic Support defines an elastic foundation between the selected faces of a part or assembly and the ground. This connector resists tension and compression.

When should a spring connector be used?

You define a spring connector when you want to model actual springs in your simulation, for example, shock absorbers in an automotive suspension. Without spring connectors, you must model the actual geometry of the spring, mesh it, and impose necessary contact conditions.

How do you simulate in SolidWorks?

1 Click Tools, Add-Ins. The Add-Ins dialog box appears. 2 Check the checkboxes next to SolidWorks Simulation. If SolidWorks Simulation is not in the list, you need to install SolidWorks Simulation.

Special Project