Which choice is not a standard 3D view in SOLIDWORKS?

Which choice is a standard 3D view in Solidworks?

The Standard 3 View option under Insert > Drawing View creates three related default orthographic (front, right, left, top, bottom, and back) views of a part or assembly displayed at the same time. The view orientations used are based on the orientations (Front, Right, and Top) in the part or assembly.

How do I view 3D in Solidworks?

To access the 3D Views tab, click the 3D Views tab at the bottom of the SOLIDWORKS window: A resizable pane appears at the bottom of the screen. It includes 3D View controls that let you: Capture 3D views.

What are the standard three views in a drawing?

Standard views typically include the 3 principle views – front, top, right side. There are several methods for generating the standard drawing views.

What are the three standard views we show on your drawings?

Although six different sides can be drawn, usually three views of a drawing give enough information to make a three-dimensional object. These views are known as front view, top view and end view.

IT IS INTERESTING:  What is the difference between CAD and technical drawing?

What is model view in SOLIDWORKS?

Model View creates a single view based on a predefined view orientation. The Model View PropertyManager appears when you create a new drawing, or when you insert a model view into a drawing document.

What are the typical standard drawing views?

The most common way to communicate all the information is by using three different views in a multiview drawing: Front view. Top view. Side view.

What is the 7 views of an object?

Front, top, right side, left side, rear, and bottom. True or False? There are an unlimited number of possible directions for an auxiliary view, depending on the angle of features within an object. You just studied 10 terms!

What are the types of view?

Types of Views

  • General – A view that you orient and is not dependent upon any other view for its orientation.
  • Projection – An orthographic projection of an object as seen from the front, top, right, or left. …
  • Auxiliary – A view created by projecting 90 degrees to an inclined surface, datum plane, or along an axis.

What are the three principal views of an object?

Generally, three views of an object are prepared. These are Top View, Front View, and Side View. If the plane is kept in a vertical position, then it is called the vertical plane.

What is the standard type of three-dimensional view shown on blueprints?

Isometric drawing render a three-dimensional view of an object in which the two sets of horizontal lines are drawn at equal angles and all vertical lines are drawn vertically.

IT IS INTERESTING:  Question: How do you increase scratch memory in Ansys?
Special Project