Quick Answer: How do I calculate volume in AutoCAD Civil 3D?

To calculate volumes in Civil 3D 2014: After creating your ground surface and your graded surface, click the Analyze Tab → Volumes and Material Panel (as shown above).

How do I create a volume report in Civil 3D?

Generate a volume report

1. Open Earthworks-2. dwg, which is located in the tutorials drawings folder. …
2. Click Analyze tab >> Volumes And Materials panel >> Volume Report .
3. In the Report Quantities dialog box, specify the following parameters: Select Alignment: Centerline (1) …
4. Click OK.
5. The report is displayed.

How is 3D area calculated in Civil 3D?

Answer

1. Select the required surface.
2. Select Surface Properties (from the ribbon, Prospector or right mouse button)
3. Select the Statistics tab.
4. Open the ‘Extended’ group.
5. The 2D and 3D surface area are displayed as shown.

How do you get cut and fill volume in Civil 3D?

Solution:

1. In command line type “COMPUTEMATERIALS”.
2. Select the alignment and sample line group to sample, then click “OK”.
3. Change “Quantity takeoff criteria” to “Cut and Fill” or other desired criteria.
4. Map the sampled surfaces to the correct object names, then click “OK”.

How do you find the volume of a 3D object?

Calculating Volume for Various 3D Objects

1. Cube. Volume = s³ = s x s x s. Where s is the length of the side of the cube. …
2. Rectangular Prism. Volume = l x w x h. …
3. Cylinder. Volume = area of base x h. …
4. Sphere. Volume = 4/3 x pi x r³ …
5. Cone. Volume = 1/3 x pi x r² x h. …
6. Pyramid. Volume = 1/3 x area of base x h.

Can CAD calculate surface area?

How do you calculate 3d surface area in AutoCAD? Click Home tab Utilities panel Measure drop-down Area. Find. At the prompt, enter o (Object).

How do you find the area of a sloped surface?

Multiply the hypotenuse by the length of the roof. The result is the surface area of the sloping roof. For example, if the sloping surface is 11.18 feet wide, and the roof is 30 feet long, the sloping area is 335.4 square feet — 11.18 x 30 = 335.4.

What is cut and fill factor?

n Cut factor: Compensates for the expansion factor of the material left after the cut. n Fill factor: Compensates for the compaction factor of the fill material. For example, for a material that expands 15 percent, type the value 1.15.