How do you read floor plan scales?

How do you read scale drawings?

The scale is shown as the length in the drawing, then a colon (“:”), then the matching length on the real thing. Example: this drawing has a scale of “1:10”, so anything drawn with the size of “1” would have a size of “10” in the real world, so a measurement of 150mm on the drawing would be 1500mm on the real horse.

What do the numbers mean on a floor plan?

When reading the floor plans, you will probably notice a few circles with numbers and letters inside of them. These symbols are used to indicate a cross-section of that particular room or space that can be found elsewhere in the blueprints.

What is the scale of a floor plan?

Floor plans should be drafted to scale, which means reducing the size of your drawing so the entire space can reasonable fit on a piece of paper or screen. A common scale is 1/4 inch = 1 foot. This same scale should be applied to objects like furniture or exhibit booths that will be included in the floor plan.

What does scale 1.50 mean?

1:50 is a ratio. it means you’re scaling 1 unit to 50 units. that could be inches (1″=50″) or miles (1 mile=50 miles) or anything else, but it’s a direct scale.

IT IS INTERESTING:  How do you create an area boundary in Revit?

What does P stand for in floor plans?

What does P mean on floor plan? Commonly Used Abbreviations. W.I.C. – Walk in Closet. W/D – Washer and Dryer (if shown together as with the floorplan above, that indicated the appliances are stacked) P. – Pantry. …

What is the most common scale for house plans?

Architect Scale. The architect’s scale is used by architects and builders for obtaining measurements from scaled drawings of buildings and other structures. It is typically three-sided with 11 scales or flat with 4 scales. It is available in lengths ranging from 4″ to 36″ although 12″ models are most common.

What does a 1/100 scale mean?

Ratio scales



If the scale of the plan is 1 : 100, this means the real measurements are 100 times longer than they are on the plan. So 1 cm on the plan represents a real length of 100 cm (1 metre)

What is the scale of a site plan?

The site plan (also known as a block plan) should be drawn at an identified standard metric scale (typically 1:100, 1:200 or 1:500). It should show the proposed development in relation to the site boundaries and other existing buildings on the site, with dimensions specified including those to the boundaries.

What size is 1.50 scale?

Model scales

Ratio Millimetres per foot
1:56 5.442 mm
1:55 5.644 mm
1:50 6.096 mm
1:48 6.350 mm

What is the scale of 1 25?

Well, 1:25 means that 1 ‘unit’ on the plan is 25 ‘units’ in real life, so 1cm = 25cm, 1ft=25ft etc.

IT IS INTERESTING:  Best answer: How do you edit a locked layer in AutoCAD?
Special Project