How do you break a level line in Revit?

How do you break an elevation line in Revit?

To do this, select the elevation line, in the Ribbon select the Split Segments tool and pick the elevation line where you would like to split the line, then move the split segment to the desired location.

How do you cut out a line in Revit?

You can change level lines in the following ways:

1. Resize level lines. Select the level line, click on the blue sizing handles, and drag the cursor left or right.
2. Raise or lower levels. Select the level line, and click the dimension value associated with it. …
3. Re-label the level. Select the level and click the label box.

How do you break a section to fit on a sheet in Revit?

Select your view window in the section you want to break. 2 “zig-zag” break symbols appear on each line (pictured). Click on one of these to create either a horizontal or vertical break as required. Drag the extents to create the break you want.

How do you use plan regions in Revit?

Create a Plan Region

1. Open a plan view.
2. Click View tab Create panel Plan Views drop-down (Plan Region).
3. Sketch a closed loop using lines, rectangles, or polygons.
4. On the Properties palette, for View Range, click Edit.
5. In the View Range dialog, specify the primary range and view depth.

How do you fix levels in Revit?

Add Levels

1. Open the section or elevation view to add levels to.
2. On the ribbon, click (Level). Architecture tab Datum panel (Level) …
3. Place the cursor in the drawing area and click. …
4. Draw level lines by moving the cursor horizontally. …
5. Click when the level line is the correct length.

How do you move levels in Revit?

Move Levels

1. Drag the level up or down.
2. On the Properties palette, for Elevation, enter a new value.
3. Click a dimension length between levels, and enter a new value. Moving a level in a 3D view.
4. Zoom into the view so you can clearly see the level head. Click the elevation value, and enter a new value. (

Can you break a section line in Revit?

Click the break control ( ) and adjust the length of the section line segments. The section break is in the middle of the section line. The following images show the same section, whole and broken. To rejoin the section line, click the break control again.