How do I set edges in Autocad?

How do you draw edges in AutoCAD?

The steps are listed below:

1. Type FILLETEDGE on the command line or command prompt and press Enter.
2. Type R or radius on the command line.
3. Press Enter.
4. Type 1 (radius value).
5. Press Enter.
6. Select the Edge to apply Fillet on it. Here, we have selected the edge, as shown below:
7. Press Enter.

How do you smooth edges in AutoCAD?

Go to Tools, Options, Display……….. under Display Resolution make Arc & Circle Smoothness value 100. >Go to Tools, Options, Display……….. under Display Resolution make Arc & Circle Smoothness value 100.

What is edge command in AutoCAD?

EDGE command description:



Toggles the visibility of edges on a 3DFACE. You can run the EDGE command in any localized version of AutoCAD by typing _EDGE in the commandline.

How do I set lengths in AutoCAD?

A Specific Length

1. Click Home tab > Draw panel > Line. Find.
2. Specify the start point.
3. Do one of the following to specify the length: Move the cursor to indicate the direction and angle, and enter the length, for example 6.5. …
4. Press the Spacebar or Enter.

How do you chamfer edges in AutoCAD?

To Chamfer a 3D Solid

1. Click Solid tab Solid Editing panel Chamfer Edge. Find.
2. Select the edge to chamfer. A preview of the chamfer is displayed.
3. Do one of the following: …
4. Specify the distances for the base surface and the other, adjacent surface. …
5. Do one of the following: …
6. To complete the chamfer, press Enter.

How do I create a fillet in AutoCAD?

AutoCAD Fillet

1. Select the Fillet command from the ribbon panel, as shown below: Or. Type F on the command line or command prompt and press Enter.
2. Select the first object.
3. Type R or Radius.
4. Press Enter.
5. Specify the radius of the Fillet and press Enter.
6. Select the second object.

What is the use of trim and extend command?

It is used to remove extra lines or extra parts of an object. We can also perform trim using different selection methods.

What is the use of fillet and chamfer in AutoCAD?

Chamfer command Autocad



This command bevels the edges of the objects. Fillet command curves the corner of the object whereas; the chamfer command inclines the edge at a particular angle.

What are commands in AutoCAD?

Basic AutoCAD commands

How do I find the length of a line in AutoCAD?

To measure the length of a line, polyline segments, circle and arc radii etc. simply select an element and hover the cursor over one of the end control points. Dependent on the element selected, the AutoCAD interface will display the relevant information.