How do I make sure sketch is fully defined in SolidWorks?

How do you know if a sketch is fully defined in Solidworks?

FULLY DEFINED SKETCH



The sketch is fully defined if the lines on the sketch are all black. This means that there can be no unexpected changes within the model due to all the geometry of the sketch being fully defined.

Why is my sketch not fully defined?

In this tech tip we’ll answer the common question: Why is my SOLIDWORKS Sketch Pattern Under Defined? The reason is because the sketch instances can rotate. You could previously Fully Define the instances by adding a Horizontal or Vertical relation on one of the construction lines tied to the instances.

How do you tell what is under defined in Solidworks?

Well you could open up all sketches in turn, or check the sketch name for a (-) symbol: this means the sketch is under-defined.

How do you make a sketch fully defined?

To fully define a sketch:

1. Edit a sketch.
2. Click Fully Define Sketch. (Dimensions/Relations toolbar) or Tools > Dimensions > Fully Define Sketch.
3. Set the options for relations and dimensions in the Fully Define Sketch PropertyManager.
4. Click .

What does it mean for a sketch to be fully defined?

Fully defines the sketch by applying combinations of relations and dimensions. Selected entities. Applies relations and dimensions only to specific sketch entities that you select for Entities to Fully Define. Calculate.

How do I make text fully defined in Solidworks?

Sketching Text

1. Click a face of a part.
2. Click Text. …
3. In the graphics area, select an edge, curve, sketch, or sketch segment. …
4. In the PropertyManager, under Text, type the text to display. …
5. Set the properties in the Sketch Text PropertyManager as necessary.
6. Click .
7. With the sketch still open, extrude or cut the text.

How do I move a full defined part in Solidworks?

Click Move Component (Assembly toolbar) or Tools > Component > Move. The Move Component PropertyManager appears, and the pointer changes to . Select one or more components in the graphics area. Select a component and drag in any direction.

How do you define a circular sketch pattern?

Creating Circular Sketch Patterns

1. Click Reverse direction .
2. In the graphics area, drag the selection point to select a pattern center other than the sketch origin. …
3. Define Spacing to specify the total number of degrees in the pattern.
4. Select Equal spacing to pattern instances equidistant from each other.

What is over defined in Solidworks?

Dimensions or relations are in conflict or are redundant. When you insert dimensions, they are assumed to be driving dimensions. To have two dimensions driving the same geometry is invalid. Over Defined Dimension Example. Over defined relations display the over defining sketch entities and relation callouts in yellow.