How do I make stairs go down in chief architect?

From the County Clerk. Visit the county clerk’s office in the county where your home resides. This may be called the county recorder or land registrar in some municipalities. Once there, request copies of the blueprints on file for the property.

How do you put a landing on stairs?

How to Build Stairs with a Landing

1. Step 1: Finish Decking First.
2. Step 2: Make Lower-stair Stringers.
3. Step 3: Install Center Stringers.
4. Step 4: Attach Stringers to Pad.
5. Step 5: Attach Toe-kick.
6. Step 6: Attach Stringers to Toe-kick.

How do I change elevation in chief architect?

Select Terrain> Elevation Data> Elevation Line from the menu, then click and drag to draw an elevation line. Click on the line to select it, then click the Open Object edit button. On the Elevation panel of the Elevation Line Specification dialog, set the Elevation at 100′ and click OK.

How do you add a second floor in chief architect?

ANSWER

1. Create a new floor by selecting Build> Floor> Build New Floor. …
2. In the New Floor dialog, select Make new blank plan for the 2nd floor, then click OK.
3. In the Floor Defaults dialog that displays next, specify your desired floor and ceiling settings, then click OK to create a new blank floor level.

Do deck stairs have to land on concrete?

Stair stringers should always land on a level and well-drained surface. If you are landing on a concrete pad or a patio, this should not be a problem. … A 3′ x 3′ level landing area is required at the base of all staircases. The ground may qualify if it meets the requirements.

How do I change dimensions in chief architect?

To change the dimension defaults

1. Select Edit> Default Settings .
2. In the Default Settings dialog, expand the Dimension category, select Dimensions, then click Edit. …
3. In the Saved Dimension Defaults dialog that displays, choose the appropriate Dimension Default from the list, then click Edit once again.

How do I find elevations in chief architect?

ANSWER

1. Navigate to 3D> Create Orthographic View, then select the Cross Section/Elevation , Backclipped Cross Section , or Wall Elevation tool. …
2. With the tool selected, click and drag towards a wall to create a section/elevation view.