Frequent question: How do you make a pipe in Solidworks?

How do I enable piping in Solidworks?

Enabling the Routing Add-In

  1. From the SOLIDWORKS menu bar, click Tools > Add-Ins .
  2. From the Add-Ins dialog box, under SOLIDWORKS Premium Add-ins: To use Routing in your current SOLIDWORKS session, select Routing under Active Add-ins. To use Routing in every SOLIDWORKS session, select Routing under Start Up.
  3. Click OK.

How do you make a curved pipe in Solidworks?

Tutorial – Making a pipe bend in SolidWorks?

  1. Start SolidWorks in Part mode.
  2. Right Plane >> Sketch and make a circle.
  3. Extrude surface it.
  4. Make two planes at the edges of these surfaces.
  5. Select the right edge plane >> Sketch.
  6. Convert the edge of the surface.
  7. Under features tab choose curve>>helix and spiral.

How do I create a piping layout?

Piping Layout Guidelines



Piping for vertical vessels should be located radially around the vessel on the pipe rack side, or should align with adjacent equipment. Leave adequate space for access to platforms, ladders, manways, instruments and drop areas.

How do you cut a tube in SolidWorks?

To cut pipes or tubes that penetrate each other:

  1. In the FeatureManager design tree, expand the route assembly .
  2. Right-click Route. …
  3. Right-click the point where the straight run and the branch intersect (the intersection of the 3D sketch segments), and select Penetrate.
IT IS INTERESTING:  How do I install Fusion 360 on my Mac?

How do you make a 3D sketch in SolidWorks?

To create a 3D sketch, click 3D Sketch (Sketch toolbar) or Insert > 3DSketch . You can create 3D sketch entities on a working plane, or at any arbitrary point in 3D space. In 3D sketching, a graphical space handle helps maintain your orientation while you sketch on several planes.

How do you make a hollow cylinder in SolidWorks?

To Make a Hole Through the cylinder:

  1. Select the front face of the cylinder by clicking on the circumference. …
  2. Click Exit Sketch, then select the smaller circle by clicking on the circumference.
  3. Select Extrude Cut, and in the Property Manager that appears on the left of your screen, make D1 60mm.

How do you flex in SolidWorks?

To create Flex features, click Flex (Features toolbar) or Insert > Features > Flex, set the PropertyManager options, and click .



Repositioning the Triad and Trim Planes

  1. Select a coordinate system feature .
  2. Change the Rotation Origin. , …
  3. Change the Rotation Angle , , or to rotate the triad around these axes.
Special Project