Can you dimension to hidden lines in Solidworks?

Can you dimension to a hidden line?

Avoid dimensioning to hidden lines wherever possible. 7. Dimensions should not be placed on the object unless that is the only clear option. intermediate dimension can nest closer to the object to avoid crossing extension lines.

How do I make lines invisible in Solidworks?

Right-click the drawing view and select Properties. Select the Show Hidden Edges tab. Select a feature or component from either the drawing view or the FeatureManager design tree to add it to the list of items to be shown with hidden lines. Click Apply to see the effect of your selection.

How do I show hidden ordinate dimensions in Solidworks?

Showing Dimension Names

To show dimension names: Click View > Hide/Show > Dimension Names or Hide/Show Items > View Dimension Names (Heads-up View toolbar).

What dimensions should write on dimension line?

Dimensions should be written on a drawing, according to one of the following two methods. Only one method should be used on any one drawing. Dimensions should be placed parallel to the dimension lines and preferably near the middle, above and clear off the dimension line (Fig. 16a).

How do you dimension a floor plan?

Room dimensions are presented in width by the length. For example, a room that has a dimension of 12′ x 16′ means it’s 12 feet wide (from side to side) by 16 feet long (from top to bottom). Rooms aren’t always square, so make sure you understand fully how the room feels.

How do you show hidden lines in Solidworks 2020?

To control how hidden edges are displayed:

1. Click Tools > Options > System Options > Display.
2. Select Solid or Dashed for Hidden edges displayed as.
3. Click OK.

How do you hide a tangent line in Solidworks?

Other options for tangent edge display are in the Hide/Show Edges PropertyManager. You can control tangent edge display in the following ways: Default – to set the display for all new drawing views, click Options. > Display Style, and choose one of the options under Tangent edges in new views.

How do I show hidden parts in Solidworks assembly?

Right-click on the blank graphics area and select “Show Hidden Components.” SOLIDWORKS will display any components hidden in the assembly. If you click on the component, it will show it when you exit this state (which can be done by clicking Escape on your keyboard or clicking “Exit Show-Hidden”).

How do you show dimension names in Solidworks?

To show dimension names, click View > Dimension Names or, from the Heads-up View toolbar, click Hide/Show Items > View Dimension Names. Search ‘Dimension Names’ in the SOLIDWORKS Knowledge Base.

How do I show hidden components in Solidworks?

To select hidden components to be shown:

1. Click Show Hidden Components (Assembly toolbar). The Show Hidden dialog box appears. …
2. In the graphics area, select components you want to show. The components you select disappear temporarily.
3. In the dialog box, click Exit Show Hidden.

What width of the line is used in dimension lines?

The dimension line is a thin line, broken in the middle to allow the placement of the dimension value, with arrowheads at each end (see diagram below). An arrowhead is approximately 3 mm long and 1mm wide. That is, the length is roughly three times the width.

What is a hidden line?

Hidden lines in a drawing represent the edges where surfaces meet but are not directly visible. Hidden lines are omitted from pictorial drawings unless they are needed to make the drawing clear.

What are the 3 types of drawing dimensions?

The basic types of dimensioning are linear, radial, angular, ordinate, and arc length.