Best answer: How do you edit a roof extrusion in Revit?

How do you edit a roof in Revit?

Modify a Roof

  1. Select the roof, and click Modify | Roofs tab Mode panel (Edit Footprint) or (Edit Profile).
  2. Make necessary changes. …
  3. Click (Finish Edit Mode).

How do you do a roof extrusion in Revit?

Create a Roof by Extrusion

  1. Display an elevation, 3D, or section view.
  2. Click Architecture tab Build panel Roof drop-down (Roof by Extrusion).
  3. Specify the work plane.
  4. In the Roof Reference Level and Offset dialog, select a value for Level. …
  5. To raise or lower the roof from the reference level, specify a value for Offset.

How do you change the roof texture in Revit?

Modify type properties to change a roof family’s structure, fill pattern, and more. To change type properties, select an element and click Modify tab Properties panel (Type Properties). Changes to type properties apply to all instances in the project.

Can the roof by extrusion tool be used in a plan view?

This is more easily done in a plan view, so switch to the Level 2 plan view. Then select the roof again, and on the contextual ribbon, click Vertical. When you use the Vertical Opening tool, you must create a closed loop. The area inside that closed loop will then be cut away from the roof.

IT IS INTERESTING:  Question: How do I model for InfraWorks?

How do you add materials to a roof in Revit?

Apply a Material to the Face of an Element

  1. Click Modify tab Geometry panel (Paint).
  2. In the Material Browser dialog, select a material. …
  3. Place the cursor on the element face to highlight it. …
  4. Click to apply the paint.
  5. In the Material Browser dialog, click Done.

How do you change the pitch on a roof?

Pitched Roof

  1. Change the pitch on an existing sloped roof by removing the old roof and framing. …
  2. Remove rafters or trusses one at a time. …
  3. Use prefabricated trusses to put a new pitch on the roof. …
  4. Raise trusses to the roof, spaced at 24-inch intervals.

How do you annotate roof slope in Revit?

Add a Spot Slope Dimension

  1. Click Annotate tab Dimension panel (Spot Slope).
  2. In the Type Selector, select the type of spot slope to place.
  3. (Optional) Change the following on the Options Bar: …
  4. Click the edge or slope where you will place the spot slope.
  5. Click to place the spot slope, either above or below the slope.
Special Project