Where is section view solidworks?

How do I view sections in Solidworks?

(View toolbar) or View > Display > Section View.

…

Section Views in Models

1. Select bodies or components to include in or exclude from section views.
2. Toggle the view off and on. …
3. Show or hide a section cap. …
4. Select the faces, edges, and vertices created by a section view.

How do I get out of section view in Solidworks?

Removed Section Views

1. In a drawing, select a view.
2. Click Removed Section (View Layout CommandManager tab or Drawing toolbar).
3. In the PropertyManager, for Edge and Opposed Edge, select two edges from the same drawing view. …
4. Select a cutting line placement method: …
5. Move the pointer and click to place the view.

What is a full section view?

Full Section. ∎ In a full section, the cutting plane line. passes fully through the part. ∎ Normally a view is replaced with the full. section view.

What is removed sectioning?

A section removed from its normal projected position in the standard arrangement of views is called a “removed” section. Such sections are labeled SECTION A-A, SECTION B-B, etc., corresponding to the letter designation at the ends of the cutting plane line.

How are section lines shown?

Rule 1: A section lined area is always completely bounded by a visible outline. Rule 2: The section lines in all areas should be parallel. Section lines shown in opposite directions indicate a different part. Rule 3: All the visible edges behind the cutting plane should be shown.

Do you show hidden lines in a section view?

Section views do not include hidden lines. Any material cut when a section view is defined is hatched using section lines. There are many different styles of hatching, but the general style is evenly spaced 45° lines.

Is a type of section where the cutting plane is thrown vertically?

Sectional Front View:



When an object is cut by a vertical cutting plane or Auxiliary Vertical Plane, the front view obtained is called the Sectional Front View.

When and why is a section view necessary?

In which case, the direction of sight is towards one half of the object. The other half is then mentally discarded. Drafters use sectional views to improve the clarity of complex objects when internal surfaces result in too many hidden lines. Special conventions are used to make a sectional view easy to understand.