What is a match line in architecture?

What is match line on a map?

Those lines indicate where the narrative directions begin and end. In other words, before you can travel from map panel to map panel, you must first travel from matchline to matchline.

What is a match line Autocad?

Match line annotations are used for annotating a drawing. Formerly available as content blocks in DesignCenter, these annotations are now available through tools on the tool palettes and in Content Browser.

What is a match line on a print?

A “matchline” refers to the line drawn on a pattern where the plaid or stripe fabric must be matched in order that the textile pattern appears to flow unbroken across seam lines.

Why do maps match?

The goal of map matching is to infer the trajectory that the device followed in a road network from a potentially sparse series of noisy location measurements.

Is match line one word?

is match line one word or two? YES! YES!

How do you use match line in Revit?

Add a Matchline

1. Open the primary view from which your dependent views were created.
2. If crop regions are not visible, click (Show Crop Region) on the View Control Bar. …
3. Click View tab Sheet Composition panel (Matchline).
4. Sketch the matchline.
5. When finished, click Finish Matchline.

What is Matchline Civil 3d?

Match lines have a match line mask area on the outside of each match line. Use the match line mask area to hide or mask the area that exists between the outside of a match line and the inside border or boundary of the view frame. This component exists only in plan views, not profile views, and only in paper space.

How do I match in Autocad?

To Copy Properties From One Object to Other Objects

1. Click Home tab > Properties panel > Match Properties. Find.
2. Select the object from which you want to copy properties.
3. If you want to specify which properties are copied, enter s (Settings). …
4. Select the objects to which you want to copy the properties, and press Enter.

How do I match linetypes in Autocad?

Type PSLTSCALE in the Command line, and type 1 when prompted to Enter a value. The linetype scale of this Viewport (in Paper Space) will now match the linetype scale you’ve already set in the original drawing (in Model Space).

How do I add a match line in Civil 3d?

To Insert a Match Line in the Drawing

1. Select a match line tool on a tool palette. …
2. Specify the first point of the match line in the drawing area.
3. Specify the next points of the match line, and press Enter when the line is complete.