Quick Answer: How do you show properties in Fusion 360?

How do I change properties in Fusion 360?

How to change the units within Properties in Fusion 360

1. Press the arrow next to Document Settings.
2. Click on Units to change the active units.
3. Change to desired units.
4. Check Properties and the units will reflect the document units.

How do you show sections in Fusion 360?

The Section Analysis tool creates a section of a model and allows to see inside it:

1. Choose Inspect -> Section Analysis.
2. Select a face or plane for the section view to start on.
3. Use the manipulators to position the section view.
4. Click OK. Fusion will add the section view to the Analysis folder in the browser tree.

How do you add material properties in Fusion 360?

You can import materials directly into Fusion 360, but you can take material properties you find on Matweb and create your own custom materials with your own properties. To do this, right click anywhere in the design environment and select Physical Materials.

How do I add materials to the library in Fusion 360?

Solution:

1. Open the Material Library.
2. Choose a material that is similar to the desired material.
3. Apply that material to an object so that the picture of that material is under the “In This Design” tab in the Material Library Dialogue.
4. Right Click on the Thumbnail image of the Material.
5. Select Duplicate.

How do you show mass in Inventor?

Q: How do I determine the mass of my parts in Inventor? On the iProperties dialogue, click on the Physical tab (you may need to click update). Your Mass, Area and Volume are displayed below.

Where can you find the center of mass measurement at in Fusion 360?

Display the Center of Mass

• Select Inspect > Center of Mass.
• Select components or solid bodies to be included in the center of mass calculation.
• Click OK.
• Click to select the center of mass to display its coordinates in the global coordinate system.

How do you do a section view?

A full section view is generated by running the cutting plane through the entire length of the object being sectioned.

1. Click Layout tab Create View panel Section drop-down Full. …
2. Click the view you want to use as the parent view. …
3. Click in the drawing area to indicate the start point of the section line.

How do you draw a section line?

You draw a section line by specifying a start point, an endpoint, a length, and a height for the section. You can specify additional points between the start point and the endpoint to create jogs in the section. The section line acts as a cutting plane, slicing a section from the building model.

Does Fusion 360 have configurations?

The Derive functionality that is built into Fusion 360 can allow for configurations of parts that stem from a base model, or is derived from one.