Question: Can you kink a section in Revit?

How do you flip a section in Revit?

Use the Rotate tool to rotate a section view or a scope box.

1. Open the project view that contains the section (callout) or scope box to rotate.
2. Select the section (callout) or scope box.
3. Click Modify tab Modify panel (Rotate).
4. Rotate the view.

How do you make a jagged section in Revit?

Select it, Then in the ribbon under Modify / Views, click the “Split Section” button. the cursor will show a knife. click on the section where you want to make the cut and drag the section to make the kinked split.

Can you break a section line in Revit?

Click the break control ( ) and adjust the length of the section line segments. The section break is in the middle of the section line. The following images show the same section, whole and broken. To rejoin the section line, click the break control again.

How do you create a jog in a building section Revit?

But you can ‘Jog’ or offset a section line.

1. Sometimes a Jogged Section line comes in very handi. …
2. Start the Section tool and click the two end points of a single straight segment.
3. Then click on the section line and note the Split Segment button on the options bar at the top.
4. Click the Split Segment button.

How do you split a long section in Revit?

Select your view window in the section you want to break. 2 “zig-zag” break symbols appear on each line (pictured). Click on one of these to create either a horizontal or vertical break as required. Drag the extents to create the break you want.

How do you insert a section box in Revit?

Select elements in the view, and then on the Modify tab, click Selection Box. The elements in the extension define the extents of the section box. The selection box tool can be used in 2D view. When used in a 2D view, the section box is applied to the default 3D view of the project.

How do you stagger a section line in Revit?

Staggering a Section view in Revit

1. Simply select the section line and access the split segment tool orthogonally moving parts of the section cut line to include or exclude objects from being shown in the section view.
2. Drag the handles of the clipping extents if necessary, to control the section view extents.