How does Revit calculate cut and fill?

Go to Solution. To find the exact location of where the backup files are located type in op in AutoCAD. This will bring up the options window. Now under the files tab there should be a folder called Automatic Save File Location.

How do you show cut and fill in Revit?

View the Cut/Fill Volumes

1. Create a toposurface.
2. In the site plan view, select the toposurface.
3. On the Properties palette, set Phase Created to a phase earlier than the view’s phase. …
4. Optional. …
5. Click (Finish Surface).
6. Select the toposurface copy.

How do you calculate cut and fill volume by hand?

This method involves drawing horizontal and vertical lines over your site plan to divide it into grid cells of equal size. You then include the existing elevation and proposed elevation for each corner of the grid cells, and work out the difference between the two, as this will be cut or fill depth for that spot.

Is cut and fill expensive?

Costs. Builders say that putting a concrete slab on a cut and fill site is cheap, and it is until you factor in extra costs to solve the drainage problems that occur after the builder has long gone. Putting in drainage after completion of the home is very expensive.

How do you calculate fill area?

Rectangular Area

1. Measure the length, width and depth of the area you want to fill with dirt. …
2. Calculate the volume of dirt needed to fill the area you measured by multiplying length (120 inches) by width (60 inches) by depth (30 inches). …
3. Convert cubic inches to cubic yards by dividing by 46,656 cubic inches.

What is the Colour given for cutting or embankment area?

38. Embankment Symbol. Embankment symbol colour is Black.

How is cut off marks calculated?

First, take your mathematic marks divide it by 2, then you will get the marks for 100. Marks of physics and chemistry should be divided by 4, then you would get marks for 50 for each subject. This is the normal process to getting cutoff marks.

How do you get cut and fill volume in Civil 3d?

Solution:

1. In command line type “COMPUTEMATERIALS”.
2. Select the alignment and sample line group to sample, then click “OK”.
3. Change “Quantity takeoff criteria” to “Cut and Fill” or other desired criteria.
4. Map the sampled surfaces to the correct object names, then click “OK”.

Why do we need to know the mass diagram?

Mass diagrams indicate the spatial relationship between excavation (cut) and embankment (fill) on a project and are good tools in planning for efficient earthwork operations. The basic excavation and embankment volumes and locations must be known before the mass diagram can be constructed.

What is a cut and fill slope?

Cut and fill slopes means a portion of land surface or area from which soil material is excavated and/or filled forming a slope or embankment.