How do you show yield strength in Solidworks simulation?

How do you show material yield strength in SOLIDWORKS Simulation?

The yield strength value is displayed at the bottom of the plot legend. When checked, the local coordinate system reference triad is displayed at the lower right corner of the graphics area. The triad is displayed only for plots where you define a reference plane, axis, or coordinate system.

What is yield strength in SOLIDWORKS Simulation?

Yield Strength is the point at which the material will start to deform plastically. Yield Strength is used in pin bolt safety, fatigue, costing, factor of safety, linear static analysis, von Mises stress, Mohr-coulomb stress.

How do you show min and max stress in SOLIDWORKS Simulation?

Edit the Stress Plot definition and enable the option ‘Show plot on selected entities’. Either select face(s) or bodies/component(s) to show the stresses on just those regions. Then on the Chart Options tab, select the options ‘Show max annotation’ and ‘Show Min/Max range on shown parts only’.

How do you do a strength analysis in Solidworks?

To set up stress analysis on one or more components:

1. Click Simulation Setup (MotionManager toolbar).
2. In the graphics area, select a component on which to perform the stress analysis. …
3. Enter the Start Time and End Time for the analysis. …
4. Click Add Time. …
5. Repeat Steps 3 – 4 to compute stress analysis on other time intervals.

What is measured by yield strength?

Yield strength refers to an indication of maximum stress that can be developed in a material without causing plastic deformation. It is the stress at which a material exhibits a specified permanent deformation and is a practical approximation of the elastic limit.

How do I get material properties in Solidworks?

Document Properties – Material Properties

1. In a part document, click Options or Tools > Options.
2. On the Document Properties tab, click Material Properties.
3. Type the material density in the Density box. …
4. Under Area Hatch/Fill, select from the following: …
5. If you select Hatch, do the following: …
6. Click OK.

Is tensile a strength?

Tensile strength is defined as the “resistance to lengthwise stress, measured by the greatest load in weight per unit area pulling in the direction of length that a given substance can bear without tearing apart” (Webster’s New World Dictionary of the American Language, 1959).

What is elastic modulus in Solidworks?

For a linear elastic material, the elastic modulus in a certain direction is defined as the stress value in that direction that causes a unit strain in the same direction. Also, it is equal to the ratio between the stress and the associated strain in that direction.

How do you edit material properties in Solidworks?

Editing a Custom Material

1. In a part document, right-click Material in the FeatureManager design tree and select Edit Material.
2. In the material tree, browse to a custom library and select a custom material.
3. Edit properties of the material, then click Save.

How do you plot stress in Solidworks?

Plotting Principal Stresses

1. In the Simulation study tree, right-click the Results folder and select Define Stress Plot.
2. In the PropertyManager, under Display: Set Component to VON: von Mises stress. Select the desired Units .
3. Under Advanced Options: Select Show as tensor plot. …
4. Set other options and click .

What types of analysis can SOLIDWORKS Simulation perform?

SOLIDWORKS Simulation Professional enables you to optimize your design, determine product mechanical resistance, product durability, topology, natural frequencies, and test heat transfer and buckling instabilities. It can also perform sequential multi-physics simulations.

How do I read SOLIDWORKS Simulation Results?

Displaying SOLIDWORKS Simulation Results in the Graphics Area

1. Open an assembly that has a simulation study saved with it.
2. Click the Static 1 tab.
3. In the Simulation Study tree, right click Static 1 and click Run.
4. Click the Model tab.
5. Click Simulation Display (View toolbar) or View > Display > Simulation Display .