How do you move internal points in Revit?

How do I move a base point over 10 miles in Revit?

If you are wanting to move the project base point to a new location outside of 10 miles from origin

1. In 2020.2. 1 and earlier: Un-clip base point and use Relocate Project to move project base point.
2. In 2020.2. 2 and later: Go to Manage > Coordinates > Specify Coordinates at Point.

How do you change coordinates in Revit?

Click on the Manage Tab > Coordinates > Specify Coordinates at a Point. Click on the model line at the known origin point. The Specify Shared Coordinate dialog will open. Enter the coordinate values, the correct datum (Elevation) and the angle to True North.

Can you move project base point?

Move the project base point to the internal origin



Select the project base point and unclip it. Right-click the project base point, and click Move to Startup Location.

How do I relocate a project in Revit?

Relocate the Model

1. Click Manage tab Project Location panel Position drop-down (Relocate Project). The Relocate Project tool works similar to the Move tool. As you move the cursor over elements, valid references are highlighted and identified in the status bar.
2. Move the project graphically in the view.

What is Survey point in Revit?

The survey point is used to correctly orient the building geometry in another coordinate system, such as the coordinate system used in a civil engineering application. In a Revit model, the survey point defines a reference point for the survey coordinate system.

How do I move an entire model in Revit?

Relocate the Model

1. Click Manage tab Project Location panel Position drop-down (Relocate Project). The Relocate Project tool works similar to the Move tool. As you move the cursor over elements, valid references are highlighted and identified in the status bar.
2. Move the project graphically in the view.

How do I change the elevation of a project in Revit?

Manage tab> Project Location> Coordinates> Specify Coordinates at Point:

1. Select the ground level line and specify elevation:
2. Ground level still says 0. Select the ground level line and change the type to Shared Datum:
3. Ground level now shows the Shared Datum levels:

How do you rotate a project base point in Revit?

Click Manage tab Project Location panel Position drop-down (Rotate True North). Specify the direction of True North using one of the following methods: On the Options Bar, for Angle from Project to True North, enter a value to set the angle of rotation.

How do you change the base level in Revit?

Specify the Base Level for Incoming Geometry

1. Select the imported or linked geometry.
2. On the Properties palette, set the Base Level and Base Offset instance parameters. Alternatively, you can select the geometry in an elevation view and move it to adjust the base offset value.