How do I restore tools in Catia?

How do I find the lost toolbar in CATIA?

Right click at the bottom right corner of the Catia screen, and you’ll see all the available toolbars. Just check the one you want to see.

How do I show Toolbars in CATIA?

To launch a toolbar, select View tab > Toolbars, as shown:

1. The next to the name of the toolbar indicates that the toolbar is launched. …
2. To restore the original positions of a toolbar, select the Tools tab > Customize > Toolbars (tab) > button, as shown:
3. Each toolbar contains a separator ( ,

How do I restore CATIA settings?

Select the Tools > Options… command.

…

The options are as follows:

1. of this tabpage: restores the default settings for all options on the current tab.
2. for the selected workbench only: restores the default settings for all options on all categories in a selected workbench (included in a solution)

How do I add Tools to CATIA?

In CATIA, select Tools >> Customize, pick the Toolbars tab then pick the New… button. 2. Select the new toolbar from the list, then pick Add Commands to add the TcIC commands available from the list.

Where do I find Tools in CATIA?

Go to View > Toolbars and check if enabling any of the listed toolbars displays the icon.

How do I open sketch Tools in CATIA?

In CATIA, a sketch is drawn in the Sketcher workbench. To invoke the Sketcher workbench, choose the down arrow available on the right of the Sketcher button in the Sketcher toolbar; a flyout appears.

How do I restore a tree specification in CATIA?

To do this you will need to turn off the Geometry by selecting View -> Geometry. This will uncheck it. Then select ‘Fit all In’. This should Bring the Spec Tree from the unknown.

Where is the surface toolbar CATIA?

The toolbars are located on the right in the default set-up except for Tools, Measure and Analysis toolbars which are located along the bottom and User Selection Filter toolbar which appears when checked in the View > Toolbars menu bar.

How do I reset CATIA v5?

To reset the position of selected elements only, first select the elements, then click the Reset Position icon . The selected elements are reset to their initial position.

How do I create a tool catalog in CATIA?

Creating a Catalog

1. From the CATIA Start menu, select Infrastructure > Catalog Editor to open the Catalog Editor workbench .
2. Create a catalog from scratch using one of both methods available: Using the Catalog Editor interactive commands: Activate the chapter under which you want to create a chapter or a subchapter.