How do I delete part of a spline in Solidworks?

Contents

How do I delete part of a spline?

To Add or Delete a Point on a Spline. To add a point to a spline, right-click a spline anywhere other than on its existing points and endpoints and click Add Point. To delete a point or an endpoint from a spline, right-click a point or an endpoint and click Delete Point.

How do I edit a spline in SOLIDWORKS?

To edit splines:

Select a spline or a spline point to edit any of the following: Spline points: Select and drag a spline point to display the Point PropertyManager. …
Examine the results, and if necessary, under Parameters: Click Reset This Handle to return the spline handle to its original state. …
Click .

How do I delete a spline point in SOLIDWORKS?

Deleting Spline Points

In an open sketch, select a point and press Delete.

How do you edit a spline?

Modify a Spline

Select the spline.
Click Modify | Lines tab Edit Spline panel (Add Control) or (Delete Control). Add Control adds a control point to the spline. …
To move a control point, drag it to a new location.
To move spline end points, select the spline.

What is a spline in SolidWorks?

A Spline sketch is defined by its continuously changing curvature. Points are placed to shape the curve. Unlike standard geometry, it is common to leave Splines under defined in sketches. It can be complex to constrain the curve whilst maintaining a smooth, free flowing shape.

IT IS INTERESTING: How do you check material weight in Solidworks?

How do you dimension a spline in SolidWorks?

In Edit Sketch mode, in the Spline PropertyManager under Parameters, select Tangent driving. Click Smart Dimension (Dimensions/Relations toolbar) or Tools > Dimensions > Smart. Select the spline to display the handles. Select any of the handles on either end, and click to place the dimension.

Where is the fit spline tool in SolidWorks?

To open the Fit Spline PropertyManager: In an open sketch, click Fit Spline. (Spline Tools toolbar) or Tools > Spline Tools > Fit Spline. In the graphics area, click the sketch entities to fit to the spline.

How do you delete a point in Solidworks?

To delete a jog point: Right-click the jog point (the pointer changes to when it is over a jog point) and select Delete Jog Point.

What is a spline in math?

In mathematics, a spline is a special function defined piecewise by polynomials. In interpolating problems, spline interpolation is often preferred to polynomial interpolation because it yields similar results, even when using low degree polynomials, while avoiding Runge’s phenomenon for higher degrees.